• Model:EFSC0/10

0-10v Fan Speed Controller - EFSC 0/10

£ 125.94 (excl. VAT)

£ 151.13 (inc. VAT)

The EFSC 0/10 is a 240-volt Fan Speed Controller available in either 6.0 or 10.0Amp; suitable for 2 or 3 wire control of single-phase speed controllable motors. The unit can be controlled from a remote 0-10 volt dc input voltage (from a BMS system or sensor). Alternatively the control could be from a remote 10k potentiometer. The controller can be switched on and off with a remote volt free switch, this remote switch would operate a power relay within the controller breakingthe incoming live supply. The unit is housed in a plain grey ABS plastic enclosure. This model is fully suppressed to EN55014 and is also suitable for resistive lighting loads.

Specification
• Supply: 220-250V 1PH 50/60Hz
• Output load: 6 amps or 10 amps max (fan loads or resistive lighting loads)
• DC Input: 0-10V dc (0V in=min level out, 10V in=240V out)
• Input impedance: 100K
• EMC suppressed to EN55014
• Enclosure: grey ABS (200mm x 155mm x 80mm)
PDF Files


Data Sheet

Available Options

2 x MV-B Dual Switch for use with Helios HQW plate fans,1 x Helios TSW MCB Amp Transformer speed controller2 x Helios TSW 1.5 Amp Transformer speed controller3 x Vent Axia ACM 125 inline mixed flow duct fan1 x Three Phase Transformer controllers - RMT 1.5 Amp1 x Temperature Fan Speed Controller - ATCP4-WMS1 x Vent Axia ACM 100 inline mixed flow duct fan1 x Push Timer Switch - ZA41 x Helios ZNE Electronic Fan Overrun Timer3 x COM-32 x Single phase speed controller by auto-transformer - RMB 8.0 Amp3 x MWS 1.5 – Transformer Controller With Motor Protection3 x Isolator Switch - ISOSW1 x Time Delay Unit - DT20B1 x Multi Input Run On Timer - 0 - 20min - CFCU1 x TG-K3/NTC10-01 - Duct temperature sensor1 x Single phase speed controller by auto-transformer - RMB 1.5 Amp1 x 7 Day Programmable TIMECLOCK2 x MWS 3 – Transformer Controller With Motor Protection1 x WS - Reversing Switch from Helios Fans1 x Commercial Single or 3 phase Fan Reversing Switch - RS11 x Elta Variable Speed Drive IP66 - 0.37KW (1ph to 3ph)3 x Elta Variable Speed Drive IP66 - 0.75KW1 x Vent Axia ACM 125 T (Timer Model) inline mixed flow duct fan1 x Systemair Save Connect 2.0 Internet Module1 x TTC-2000 Three phase electric heater controller2 x CS2 Current Switch1 x TG-R room temperature sensor1 x Bathroom Fan -Envirovent- Silent 100 T (Timer Model)1 x REE-1 Electronic Speed Controller1 x EC-Vent control board1 x CBM Low Pressure Centrifugal Fan - CBM 10/10 4 Pole 550watt CVR1 x Elta 6 Amp Electronic single phase speed controller with TK1 x ACO 149-ACO1/EDV
Reviews
Duct Mounted Inline Filter - EU4
Duct Mounted Inline Filter - EU4
£ 44.99

Well made and robust, but it was not use for my application ...