• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,438.15 (excl. VAT)

£ 4,125.78 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x Ducting Y Piece - 125mm1 x AL 355 D2 01 - High Performance Long Cased Axial Fan1 x Soaker Sheet to suit RA630/7101 x HQD 710/4/4 Plate Axial Fan (2.2kw)1 x Ziehl-Abegg FN050-6EQ.4F.V7P11 x Acopel F400-315/1601 x Soler & Palau TCBT/6-800/L - IP651 x Flanged Spigot - 560mm1 x AL 315 EC 01 AXIALINE - High Performance Long Cased Axial Fan1 x RUCK MTP 30, Stepped Speed control1 x Spigot plate - 100mm1 x F7 Replacement Bag Filter for FT Filter Box Type 100-250mm ONLY1 x ELTA - Three Phase Transformer 3amps1 x AM pallet Delivery Surcharge1 x Anti Vibration Duct Suspension Rings - 200mm1 x Female Ducting Connector - 200mm1 x Ducting 90 Degree Bend - 710mm1 x Male Ducting Connector - 560mm1 x Spiral Ducting 1 meter - 355mm1 x Soler & Palau - Contra Rotating TCBTx2-560 - IP651 x Slim Qube SSQU22/4-3HT1 x CBM-10/10 515 6P RE VR IP55 (230V50)F V51 x Spiral Ducting 3 Meters - 355mm1 x Soler & Palau TCBT/6-355/H - IP441 x CBM 10/10 - 750watt 4P RE VR (3 Phase)2 x Vent Axia KAF Kitchen Extract Fan - 560mm - 2 Pole - Three Phase1 x Contra Rotating TCBBx2-630 Cased Axial - Single Phase - IP65 - Soler & Palau1 x Vent Axia KAF Kitchen Extract Fan - 630mm - 2 Pole - Single Phase1 x Soler & Palau VFD-T inverter 6.8 amp IP541 x Helios HRFW 355/2 TK1 x Raptor SDA350/4-1EC1 x MPS Motor to suit 500mm D4 unit1 x AW Sileo EC Plate Axial Fan - Three Phase - 710mm2 x Soler & Palau - Contra Rotating TCBTx2-500 - IP651 x Slim Qube SSQU4/4-3BHT1 x Elta EC Electronic Controller1 x ZAC- 350 -4-11 x Elta SLC560/4A-3AC - IP551 x Elta SCP710/6/8-3AC - IP551 x HRT/6-710/30-BQ E21 x Systemair AW Sileo 710-DS1 x AMD 355/2/2 High Pressure Long Cased Axial Fan1 x Soler & Palau - Contra Rotating TCBTx2-630 - IP651 x CBM Low Pressure Centrifugal Fan - CBM 9/9 4 Pole 550watt VR RE1 x Ducting 90 Degree Bend - 100mm
Reviews
Soler & Palau TCBB/4-450/H - IP65
Soler & Palau TCBB/4-450/H - IP65
£ 481.79

Delivered super promptly yesterday, next day. Only just fitt...