• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,610.06 (excl. VAT)

£ 4,332.07 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x Remote Timer Control - 13513 x CMT-2 120/50 - 0,09Kw - LG270 Single inlet centrifugal fan direct driven2 x CBM Low Pressure Centrifugal Fan - CBM 10/10 4 Pole 550watt VR4 x HIMF - Mixed Flow Fan 100mm Inline Fan1 x KBA- Inlet Mounting 3151 x Electrostatic Precipitator - 1H x 3W1 x CBT-100N Centrifugal2 x Duct Termination with Mesh - 150mm3 x DDMP 07/07 Mounting Flange1 x MTP 10, 10K, Speed control2 x Binks Bullows - Spray Booth Filter1 x CSB-60 Centrifugal fan1 x CBM Low Pressure Centrifugal Fan - CBM 9/7 4 Pole 373watt CVR1 x Round ceiling diffuser 200mm3 x DDMP 10-10 1F 1000W M6A2 DA51 x Non Vision 150mm x 150mm (Air Transfer) Grille - With Flange - MILL FINISH2 x Duct Termination with Mesh - 355mm1 x CBM 7/7 147w 4P RE-VR1 x Vent Axia Trickle & Boost Switch3 x KAD-225-F400 Rectangle Flexible Connector2 x CBT-130N Centrifugal ATEX II 3D ExtD 125*C1 x SAVE VSR 300 heat recovery unit3 x CBB-60N Centrifugal1 x Duct Termination with Mesh - 100mm1 x Comefri - TLZ 450 R - High Performance Scroll Fan3 x CBS-100 Outlet Flange for CBT-1004 x DDMP 12-12 3F 5700W M6M0 DG73 x Helios RR-250-C Centrifugal inline fan1 x KBA- Inlet Mounting 2502 x Round ceiling diffuser 250mm1 x LFBR 160 G4 - Helios Inline Filter Box - 160mm1 x Flakt Woods ME 1.6 speed controller 6.0amp - EA9011594 x CBA-100 Inlet Flange for CBT-1002 x ACO8AC/EC AutoChangeover panel1 x CBM Low Pressure Centrifugal Fan - CBM 9/9 4 Pole 550watt C VR1 x SPI-100 C Iris damper1 x KBA- Inlet Mounting 1804 x Helios ESA-1 Surface mounted Speed Control 1amp3 x VEKA INT 2000/15.0-L1 EKO1 x TD Mixvent 1100/250 EEXEIIT31 x RUCK MTP 20, 10K, Speed control1 x TUNE-R-200-3-M2 - Control Damper3 x DPD 12PM Delivery Surcharge2 x CBM Low Pressure Centrifugal Fan - CBM 7/7 6 Pole 72watt CVR2 x CAD-COMPACT 900 ADVANCED N8 - MVHR unit3 x Flat Roof Terminal -OFT 5 - Asphalt1 x Twinflow STDL315-1EC1 x DS-2/2 2-Speed Switch IP54 (Single Phase)1 x CFI In-line 150 - Carbon Filter1 x Clearflow CF Roof Mounted Vertical Discharge Centrifugal Fan - CF315/4-1AC - Single Phase3 x Biflow SB315-CON4-3 - High Temperature Bifurcated Fan2 x CBM Low Pressure Centrifugal Fan - CBM 12/12 6 Pole 736watt CVR1 x Run On Timer - 5s - 4hrs - RT5A3 x Biflow SB250-CON4-3 - High Temperature Bifurcated Fan1 x TUNE-R-200-3-M3 - Control Damper1 x ELTA - Three Phase Transformer 3amps4 x Helios HQW-355/4 - IP554 x Duct Termination with Mesh - 450mm1 x Quietflow SQS250-1ECL - Centrifugal Box Fan1 x Round ceiling diffuser 300mm1 x Elta HXP 800mm 6-Pole (Three Phase)2 x CBB-80N Centrifugal1 x Duct Termination with Mesh - 400mm1 x DS-2 2-Speed Switch (3 Phase)4 x Duct Termination with Mesh - 250mm3 x 100mm Round Connector with Damper1 x DA9/9-NT2 x DDMP 12-09 1F 1800W M6A4 DA81 x ACO3TO-ADS-VFC-7.1A1 x Backdraught Shutters 039-SFSV-63/712 x VTR 500 STD Filter Kit1 x CCpro 40 (1CC9402) Long Casing Extension1 x CMT-2 180/75 0.75KW - Single inlet centrifugal fan with inlet and outlet flange connections - 200mm1 x CBT-80N Centrifugal2 x Elta SCP400/4-1AC - IP551 x TUNE-R-200-3-M0 - Control Damper (NO ACTUATOR)1 x Envirovent Silent MV160/100S Mixvent - 100mm - (5 year warranty)1 x KBA- Inlet Mounting 2251 x DDMP 10-08 FLANGE1 x FU 15 16 Frequency Inverter2 x 125mm Round Connector with Damper1 x Silentub - STUB 2001 x ELTA - Single Phase Transformer 2amps1 x Universal Pipe Fixing Clip1 x TD160-NT Mixvent - 100mm - TD160 Timer1 x Egg Crate Grille with Dust panel filter 1 inch- 300x3002 x HIMF - Mixed Flow Fan 125mm Inline Fan1 x Flakt Woods ME 1.1 speed controller 1amp - EA9011571 x Elta SPA500/4-1AC - IP541 x ACOAS/ AC/EC Auto Changeover 8Amp2 x Potentiometer EGH 01 - for DDMP Fans1 x DDMP 09-07 1F 1000W M6A0 DA51 x Vent Axia T-Series Wall Model TX9WL2 x CBM Low Pressure Centrifugal Fan - CBM 9/9 4 Pole 550watt 3V (3-Speed)1 x CBT-130N Centrifugal1 x Clearflow CF Roof Mounted Vertical Discharge Centrifugal Fan - CF350/4-1AC - Single Phase1 x SDD-U Anti Vibration Pads1 x REB-CVF 0-10v Controller1 x Elta Variable Speed Drive IP66 - 2.2KW1 x CBM 9-9 550w 4P VR (Open Motor)1 x Elta Variable Speed Drive IP66 - 1.5KW1 x Elta Quietflow Twin SQT125-1ECL1 x Flakt Woods ME 1.3 speed controller 3amp - EA9011581 x DDMP 09/07 Mounting Flange1 x VA 9/2 T - High Temp Axial Fan,1 x RDS 1 Helios Transformer Controller With Motor Protection1 x Transformer Speed Control - RTRE- 5.0Amp1 x EHB 160 1.0kw - Helios Electric Heater Battery with Control and Sensor.1 x TecFire Intumescent Damper - Rectangular 400x400mm1 x Vent Axia T-Series Wall Model TX6WL1 x HXP450/6-1 - 6 Pole - Single Phase1 x CBM 9/7 4p 420W RE-VR1 x RTRD - Three Phase Speed Controller - 2 Amp1 x PM230-TF, AC 230V Damper Actuator, Spring Return, 2 x SPDT, 72C Thermal Fuse1 x Vent Axia SC5001 - Speed controller1 x RR EC 160 Centrifugal inline fan - Energy Efficient Motor1 x Transformer Speed Control - RTRE- 3.0Amp1 x Elta 3 Amp Electronic single phase speed controller.1 x TUNE-R-200-3-M4 - Control Damper2 x Clearflow CF Roof Mounted Vertical Discharge Centrifugal Fan - CF450/4-1AC - Single Phase1 x IR24-P - Presence detector1 x Duct Termination with Mesh - 200mm1 x TD ECOWATT 160/100 Inline Duct Fan - TD-ECOWATT1 x CPTA-E Flush mounted PIR sensor with timer
BD7/7 centrifugal M4 0.13Kw
BD7/7 centrifugal M4 0.13Kw
£ 345.00 now £ 300.00
Reviews
EM 250-E2M 01- Etamaster-250
EM 250-E2M 01- Etamaster-250
£ 128.80

Really well made but comes with no speed controler? ?and can...