• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,610.06 (excl. VAT)

£ 4,332.07 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x SG-200 Fan Guard for the HQW 2002 x Transformer Speed Control - RTRE- 1.5Amp1 x Elta Variable Speed Drive IP66 - 0.37KW (1ph to 3ph)1 x MTS10- extractor fan 3 step switch1 x Helios HQW-250/4 - IP551 x Compact SCD450/4-1AC1 x Elta 2 Amp Electronic single phase speed controller.1 x Elta 6 Amp Electronic single phase speed controller.1 x Elta - Room Sensor - Temp/Humid/C021 x Elta Variable Speed Drive IP66 - 1.5KW3 x ELM 18 EX Flexible Cuff for ERM 182 x Three Phase 3 step - 10amp Transformer controller for use with the HV Wall Mounted fans.3 x RD35S-4DW.6W.3L - 122297 (Three Phase)2 x SPI-100 C Iris damper1 x Speed Controller - REB11 x REU 7amp Speed control - Two Speed Five-Step Transformer - Trickle and Boost2 x CBM Low Pressure Centrifugal Fan - CBM 9/7 4 Pole 373watt CVR2 x Vent Axia ACM 200 inline mixed flow duct fan1 x Comefri - TLZ 450 R - High Performance Scroll Fan1 x CBM Low Pressure Centrifugal Fan - CBM 10/10 4 Pole 550watt VR2 x KBA- inlet mounting flange for CRMT 2501 x Clearflow CF Roof Mounted Vertical Discharge Centrifugal Fan - CF450/4-1AC - Single Phase1 x ACO8AC/EC AutoChangeover panel1 x PIR Sensor - PIR41 x Elta Variable Speed Drive IP66 - 5.5KW1 x DDMP 10-08 3F 2210W M6A4 DG01 x Elta Standard Ambient Flexible Connector - 560mm1 x GENIOX 11 Internal Mounted Unit1 x Biflow SB400-CON2-3 - High Temperature Bifurcated Fan1 x Transformer Speed Control - RTRE- 5.0Amp1 x Helios TSW 3 Amp Transformer speed controller1 x ELTA - Three Phase Transformer 3amps1 x RUCK MTP 20, 10K, Speed control2 x CBA-100 Inlet Flange for CBT-1001 x Remote Timer Control - 13511 x Mini Diffuser - 100mm1 x Silent 300 CZ Design PLUS Extractor Fan1 x EC Trickle and boost module - IP561 x Helios HQW-200/4 - IP553 x TUNE-R-250-3-M0 - Control Damper (NO ACTUATOR)1 x SQUARE MIXED FLOW FAN - MFQ 560mm (Three Phase)1 x Elta Standard Ambient Flexible Connector - 710mm1 x Speed Controller - REB162 x DS-2 2-Speed Switch (3 Phase)1 x 125mm Round Connector with Damper1 x FU 15 16 Frequency Inverter1 x Elta SCP400/4-1AC - IP551 x Helios ESA-1 Surface mounted Speed Control 1amp1 x Quietflow Twin SQTDCV250-1ECL1 x CBM Low Pressure Centrifugal Fan - CBM 7/7 6 Pole 72watt CVR1 x ADH E0-450 Flange - 0450 ADHE/RDHE1 x CMT-2 180/75 0.75KW - Single inlet centrifugal fan with inlet and outlet flange connections - 200mm1 x Biflow SB250-CON4-3 - High Temperature Bifurcated Fan2 x CBM Low Pressure Centrifugal Fan - CBM 9/9 4 Pole 550watt 3V (3-Speed)1 x Biflow SB315-CON4-3 - High Temperature Bifurcated Fan1 x Access Door for Circular Duct - 400 x 300 - SIZE 451 x Vent Axia Trickle & Boost Switch1 x Helios HQW-355/4 - IP551 x ERM180EXE Bracket1 x Quietflow SQS250-1ECL - Centrifugal Box Fan2 x Clearflow CF Roof Mounted Vertical Discharge Centrifugal Fan - CF315/4-1AC - Single Phase1 x GENIOX 11 Roof Mounted External Unit1 x Duct Termination with Mesh - 450mm1 x Duct Termination with Mesh - 100mm1 x Backdraught Shutters 039-SFSV-63/711 x Chaysol Da 12/12 CMAL - 736 Watt - 6 Pole1 x Soler & Palau - Contra Rotating TCBTx2-560 - IP651 x CBM Low Pressure Centrifugal Fan - CBM 9/9 4 Pole 550watt C VR1 x KBA- Inlet Mounting 1801 x DS-2/2 2-Speed Switch IP54 (Single Phase)1 x BDS 500/560 RA b/d shutter1 x Nicotra RDH G2E7-04501 x Comefri - TLZ 225 R - High Performance Scroll Fan1 x Silent 100 Window Kit - windowS1 x Round ceiling diffuser 400mm1 x Transformer Speed Control - RTRE- 3.0Amp1 x HIMF - Mixed Flow Fan 100mm Inline Fan1 x DA9/9-NT1 x AXC TP - 150mm Plastic Centrifugal Inline Fan
Reviews
DAOSL Back Draft Damper
DAOSL Back Draft Damper
£ 11.49

Look good, works well, except the shaft of the lanellae cuts...