• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,438.15 (excl. VAT)

£ 4,125.78 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x Raptor SDA350/4-1AC1 x Speed Controller - REB51 x Transformer Speed Control - RTRE- 7.0Amp1 x Direct AM Delivery Surcharge1 x Spiral Ducting 1 meter - 80mm1 x DHS 500E4 roof fan1 x ELTA - Single Phase Transformer 2amps1 x HCFC 1.7 - Reversible Speed Controller for HCF sweep fans1 x Male Ducting Connector - 180mm1 x AXC 315-6/11-2(B)-PV 300*C - Smoke Extract Fan1 x Pressed Ducting Saddle - 450mm1 x AMD 355/2/2 High Pressure Long Cased Axial Fan1 x KABT/4- 9000/5001 x Soler & Palau TCBB/4-355/H - IP441 x SEL355/4-1AC1 x AM pallet Delivery Surcharge1 x CADB/T-HE PRO-REG Series1 x Elta HWFA-650 Oscillating Wall Fan1 x Pallet Delivery Surcharge1 x Nordik International Plus 90/36 - Ceiling Sweep Fan Range1 x Ducting 90 Degree Bend - 250mm1 x Etaline 355mm E4 011 x TD4000 Mixvent - 355mm1 x Topvex SF12 HWL. Supply AHU1 x SAVE VTC 200 R High efficiency Heat Recovery Unit1 x Soler & Palau TCBB/4-560/L - IP651 x Spare filter Set for Energi Sava 300 & 400 HR unit1 x Duct Humidistat - HS4_hdt1 x Villiavent VTC low Spare Filter Set1 x Etaline 355mm - D2 01 3 Phase1 x Hydor Typhoon Circulation Fans - HVFB - 300mm1 x SEL355/2-1AC1 x Metal Inline Fan - VENT-355N1 x Male Ducting Connector - 560mm1 x Spare filter for Energi Sava 380 HR unit1 x DDMP 07-07 1F 1100W M6AO DA51 x Vent Axia INTEGRA PLUS EC1 x STF1 Oscillating Tower Fan1 x Spare filter for Energi Sava 200 & 250 HR unit1 x Classic SAX30/12AR Window/Wall Mounted1 x Nicotra Direct Delivery Surcharge1 x GENIOX 11 Internal Mounted Unit1 x Classic SAX30/12A Window/Wall Mounted1 x Gorilla HVLSX501 x Curved boot - 180mm1 x Classic SAX23/9ARB Wall Mounted1 x Gorilla HVLSX601 x Ducting Reducer Long - 1000mm to 630mm1 x FSAF450FTX 450 mounting feet (Pair)
Reviews
Duct Mounted Inline Filter - EU4
Duct Mounted Inline Filter - EU4
£ 41.95

Well made and robust, but it was not use for my application ...