• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,610.06 (excl. VAT)

£ 4,332.07 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x Soaker Sheet to suit RA10001 x Soaker Sheet to suit RA3501 x Soaker Sheet to suit RA400/4501 x Soaker Sheet to suit RA315/3001 x Remote Timer Control - 13511 x Run On Timer - 5s - 4hrs - RT5A1 x Time Delay Unit - DT20B2 x Multi Input Run On Timer - 0 - 20min - CFCU2 x Push Timer Switch - ZA41 x Helios ZNE Electronic Fan Overrun Timer2 x 7 Day Programmable TIMECLOCK1 x CMT-2 200/80 1.1KW - Single inlet centrifugal fan direct driven1 x KMBI 180 Connector rectangular/circular to install on the discharge of CMT1 x KBA- Inlet Mounting 1801 x Helios DDF-200 Roof Cowl1 x RTRD - Three Phase Speed Controller - 2 Amp1 x RTRD - Three Phase Speed Controller - 4 Amp1 x Speed Controller - REB101 x Rectangular Airbrick Adaptor1 x REU 1.5amp Speed control - Two Speed Five-Step Transformer - Trickle and Boost1 x Helios TSW 7.5 Amp Transformer speed controller1 x Transformer 5 Speed Controller - ATC1-4TK1 x Helios TSW 3 Amp Transformer speed controller1 x RDS 11 Helios Transformer Controller With Motor Protection1 x Vent Axia ACM 150 inline mixed flow duct fan1 x Helios TSW MCB Amp Transformer speed controller1 x Helios TSW 1.5 Amp Transformer speed controller1 x Helios TSW 10 Amp Transformer speed controller1 x Vent Axia ACM 100 inline mixed flow duct fan1 x MV-B Dual Switch for use with Helios HQW plate fans,1 x Systemair Save Connect 2.0 Internet Module1 x Single phase speed controller by auto-transformer - RMB 3.5 Amp1 x Envirovent Silent MV160/100T Mixvent - Timer Model - 100mm - (5 year warranty)1 x Electronic extractor fan speed controller - FSC 1.51 x REU 7amp Speed control - Two Speed Five-Step Transformer - Trickle and Boost1 x TDP-D Pressure Sensor with Display1 x Three Phase Transformer controllers - RMT 1.5 Amp
Reviews
Duct Mounted Inline Filter - EU4
Duct Mounted Inline Filter - EU4
£ 44.99

Well made and robust, but it was not use for my application ...