• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,438.15 (excl. VAT)

£ 4,125.78 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x AL 315 EC 01 AXIALINE - High Performance Long Cased Axial Fan1 x Spare filter for Energi Sava 200 & 250 HR unit1 x TD160-NT Mixvent - 100mm - TD160 Timer1 x VA140/150 KT Axial Kitchen Fan2 x AKOR Mounting Plate for GD model(VIM166423)2 x AKOR Spare Filter1 x 1mtr Round Ducting - 150mm1 x Vortice Quadro Micro 100 I - Standard Version1 x Spare filter for Energi Sava 380 HR unit1 x AKOR T3/7 Spare Motor1 x *VORT HRW 30 MONO Evo HCS - Single Room Heat Recovery Unit,1 x Airvent ceiling fan controller1 x HCF - Ceiling Fan 900mm (36 inch)1 x ACO8AC/EC AutoChangeover panel1 x Villiavent VTC 700 Spare Filter Set - F7/M5 Grade1 x Digital Room Thermostat - DRT1 x Vortice Quadro Micro 100 IT - Timer Version1 x 204x60mm 45 Degree Horizontal Bend1 x Wooden Sauna Fan Series - MM SEW 100 - Walnut1 x 204x60mm Flat Channel Clip (Pack of 5)1 x ACOAS/ AC/EC Auto Changeover 8Amp1 x F7/G4 filter kit for IDEO HR unit1 x AKOR GD - Spare Motor1 x Desk fan 9 inch - SFG91 x *VORT HRW 30 MONO Evo - Single Room Heat Recovery Unit,1 x Decor 300-C Bathroom Fan1 x Soler & Palau TCBB/4-400/H - IP441 x GENIOX 11 Internal Mounted Unit1 x Remote Indicator RED/GREEN - AM121 x EnergiSava 210 Low Energy Heat Recovery Unit1 x 5-Speed Controller for use with Elta SAX Classic Fans1 x 110 x 54mm Low Profile Plastic Ducting - 2 Meter1 x Elta - SMT 125 Mixvent Inline Fan - Clearance Stock Line1 x OZEO E ECOWATT Wireless Switch - OZEO-ECO-W1 x 110 x 54mm Flat Channel Clip (Pack Of 5)1 x CADB/T-HE 54 ECOWATT Series1 x 100mm Round Equal T Piece1 x 100mm Round Connector1 x HRU Controller1 x Commercial Single or 3 phase Fan Reversing Switch - RS11 x 220x90mm 45 Degree Vertical Bend1 x Airvent Ceiling Sweep Fan - 36 inch - 444122
Reviews
Circular Inline Silencers - 0.6M long - SLU-600
Circular Inline Silencers - 0.6M long - SLU-600
£ 50.56

I have a loft mount extractor fan which was very noisy. I ...