• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,610.06 (excl. VAT)

£ 4,332.07 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x RDH FLEX-SQUARE - ADH/RDH 04501 x DDMP 09-09 3F 2130W M6A4 DG01 x Vent Axia Silent 100T (TIMER)1 x CBA-60 Inlet Flange for CBT-601 x MEV Spider Wireless boost Switch - MEV-SWH-W1 x ENV 100 12v transformer SELV1 x Transformer Speed Control - RTRE- 5.0Amp1 x CBM Low Pressure Centrifugal Fan - CBM 10/10 4 Pole 550watt CVR2 x DDMP 09/09 Mounting Flange1 x MTS10- extractor fan 3 step switch1 x MTP 10, 10K, Speed control1 x Elta 2 Amp Electronic single phase speed controller.1 x Transformer Speed Control - RTRE- 1.5Amp3 x CMT/4-315/130-4KW - Single inlet centrifugal fan direct driven1 x Elta Variable Speed Drive IP66 - 0.37KW (1ph to 3ph)4 x ELM 18 EX Flexible Cuff for ERM 181 x Speed Controller - REB84 x RD35S-4DW.6W.3L - 122297 (Three Phase)1 x DDMP 12-12 3F 1810W M6A4 DG01 x TG-K Duct temperature sensor1 x QPTW 250C Acoustic Twin Fan with Controller2 x PIR Sensor - PIR42 x KBA- Inlet Mounting 3551 x CMT/4-280-115 2.2KW - Single inlet centrifugal fan direct driven ( LG-90)2 x Elta Variable Speed Drive IP66 - 4.0KW1 x UB47- Universal Insulated Terminal1 x Speed Controller - REB162 x CCpro 40 (1CC9402) Long Casing Extension3 x CBA-100 Inlet Flange for CBT-1002 x CBT-100N Centrifugal1 x CBM Low Pressure Centrifugal Fan - CBM 12/12 6 Pole 736watt CVR1 x TUNE-R-200-3-M4 - Control Damper1 x FRQ5-10A Inverter Speed controller1 x Multi Input Run On Timer - 0 - 20min - CFCU1 x Compact SCD450/4-1AC1 x Round ceiling diffuser 400mm1 x DDMP 07/07 Mounting Flange1 x Comefri - TLZ 450 R - High Performance Scroll Fan2 x DDMP 10-08 3F 2210W M6A4 DG01 x KBA- Inlet Mounting 2801 x CBM 9-9 550w 4P VR (Open Motor)1 x CBM Low Pressure Centrifugal Fan - CBM 10/10 4 Pole 550watt VR1 x Remote Timer Control - 13511 x Mini Diffuser - 100mm1 x VEKA INT 2000/15.0-L1 EKO1 x GENIOX 11 Internal Mounted Unit1 x DEF-CBM-RE-7 - Protection Guard2 x KAD-355-F400 Rectangle Flexible Connector3 x CMT/4-250-100 1.1KW - Single inlet centrifugal fan direct driven ( LG-90)1 x CBT-130N Centrifugal ATEX II 3D ExtD 125*C1 x TUNE-R-315-3-M4 - Control Damper1 x Biflow SB400-CON2-3 - High Temperature Bifurcated Fan1 x SAVE VSR 300 heat recovery unit2 x CBS-100 Outlet Flange for CBT-1001 x AIRVENT speed control - AIR4019611 x CMT-2 120/50 - 0,09Kw - LG270 Single inlet centrifugal fan direct driven1 x CSB-60 Centrifugal fan2 x Round ceiling diffuser 250mm1 x CBM Low Pressure Centrifugal Fan - CBM 7/7 6 Pole 72watt CVR1 x RDH Flange - 03151 x CBM 12-12 1100w 6P Three Phase1 x Flanged Damper 019-0560-STD1 x RDH Flange - 02501 x RD31S-4DW.6Q.AL - 121303 (Three Phase)1 x PM230-TF, AC 230V Damper Actuator, Spring Return, 2 x SPDT, 72C Thermal Fuse1 x VKS 355-500 Automatic shutter1 x CBM Low Pressure Centrifugal Fan - CBM 9/9 4 Pole 550watt C VR1 x Helios TSW 3 Amp Transformer speed controller1 x Speed Controller - REB31 x RD31S-4EW.6Q.AL - 122296 (Single Phase)1 x TUNE-R-200-3-M0 - Control Damper (NO ACTUATOR)2 x KBA- inlet mounting flange for CRMT 2501 x HIMF - Mixed Flow Fan 100mm Inline Fan1 x Helios RR-250-C Centrifugal inline fan1 x TUNE-R-200-3-M2 - Control Damper1 x Potentiometer EGH 01 - for DDMP Fans1 x ADH E0-280 Flange - 0280 ADHE/RDHE1 x Duct Termination with Mesh - 500mm1 x MWS 3 – Transformer Controller With Motor Protection1 x Silent 100 Window Kit - windowS1 x Transformer 5 Speed Controller - ATC1-12TK
Reviews
Vectaire Elegance Low Energy DMEV Fan Range
Vectaire Elegance Low Energy DMEV Fan Range
£ 131.69

I've had 2 of these fans for 4 years now, and they are great...