• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,610.06 (excl. VAT)

£ 4,332.07 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x ELM 18 EX Flexible Cuff for ERM 181 x Elta Variable Speed Drive IP66 - 0.75KW1 x DDMP 12-12 3F 1810W M6A4 DG01 x TUNE-R-315-3-M4 - Control Damper1 x VEKA INT 2000/15.0-L1 EKO5 x CBM Low Pressure Centrifugal Fan - CBM 12/12 6 Pole 736watt CVR3 x DDMP 10-08 3F 2210W M6A4 DG03 x CSB-60 Centrifugal fan4 x ACO8AC/EC AutoChangeover panel2 x AIRVENT speed control - AIR4019611 x CBM Low Pressure Centrifugal Fan - CBM 9/9 4 Pole 550watt 3V (3-Speed)1 x Elta Variable Speed Drive IP66 - 5.5KW2 x VTR 500 STD Filter Kit1 x Speed Controller - REB161 x Vertical Cowl and Fan (Single Phase) - RAV400-4-11 x Round ceiling diffuser 200mm3 x Electrostatic Precipitator - 1H x 3W1 x UB47- Universal Insulated Terminal2 x CBP-18/18-RC Belt Driven Centrifugal Fans2 x Mini Diffuser - 100mm1 x Speed Controller - REB81 x GENIOX 11 Roof Mounted External Unit1 x Silentub - STUB 1001 x Egg Crate Grille with Dust panel filter 1 inch- 595x5951 x EBM-Papst D3G133-BF05-14 Double inlet1 x LFBR 315 G4 - Helios Inline Filter Box - 315mm1 x Compact SCD450/4-1AC2 x SAVE VSR 300 heat recovery unit1 x CBT-100N Centrifugal4 x ACOAS/ AC/EC Auto Changeover 8Amp1 x Comefri - TLZ 560 R - High Performance Scroll Fan1 x Speed Controller - REB2.5-N1 x CO2 Room Sensor - CO2-R2 x CBM Low Pressure Centrifugal Fan - CBM 9/9 4 Pole 550watt C VR1 x CBT-130N Centrifugal ATEX II 3D ExtD 125*C1 x TUNE-R-200-3-M2 - Control Damper1 x Lo-Carbon Silhouette 100T (Timer)1 x Comefri - TLZ 450 R - High Performance Scroll Fan2 x CCpro 40 (1CC9402) Long Casing Extension1 x Biflow SB400-CON2-3 - High Temperature Bifurcated Fan2 x Potentiometer EGH 01 - for DDMP Fans2 x CMT-2 120/50 - 0,09Kw - LG270 Single inlet centrifugal fan direct driven3 x Helios RR-250-C Centrifugal inline fan2 x CBA-100 Inlet Flange for CBT-1001 x RD35S-4DW.6W.3L - 122297 (Three Phase)2 x Round ceiling diffuser 250mm1 x HIMF - Mixed Flow Fan 100mm Inline Fan1 x Vent Axia Trickle & Boost Switch1 x SD-MUB Vibration pad set1 x CBM Low Pressure Centrifugal Fan - CBM 7/7 6 Pole 72watt CVR1 x DS-2 2-Speed Switch (3 Phase)2 x TUNE-R-200-3-M0 - Control Damper (NO ACTUATOR)2 x KBA- Inlet Mounting 1802 x KBA- Inlet Mounting 2252 x Duct Termination with Mesh - 355mm1 x Electronic extractor fan speed controller - FSC 1.52 x AXC TP - 100mm Plastic Centrifugal Inline Fan2 x IR24-P - Presence detector1 x Non Vision 150mm x 150mm (Air Transfer) Grille - With Flange - MILL FINISH1 x CBM 7/7 147w 4P RE-VR1 x CFI In-line 150 - Carbon Filter2 x DDMP 07/07 Mounting Flange4 x Helios ESA-1 Surface mounted Speed Control 1amp1 x CK-60F Kit2 x ACO3TO-ADS-VFC-7.1A1 x CBA-160 Inlet Flange for CBT-1601 x CBS-100 Outlet Flange for CBT-1001 x CBT-130N Centrifugal1 x Run On Timer - 5s - 4hrs - RT5A1 x CBM Low Pressure Centrifugal Fan - CBM 10/8 4 Pole 373watt CVR1 x Silentub - STUB 2001 x Twinflow STDL315-1EC1 x 100mm Round Connector with Damper1 x HIMF - Mixed Flow Fan 125mm Inline Fan1 x TUNE-R-200-3-M3 - Control Damper1 x Helios SVR EC 160 B – SlimVent Centrifugal Fan Box2 x Elta SCP400/4-1AC - IP551 x KAD-225-F400 Rectangle Flexible Connector2 x SPI-100 C Iris damper1 x Helios HQW-355/4 - IP551 x ELTA - Three Phase Transformer 3amps1 x TD160-NT Mixvent - 100mm - TD160 Timer1 x Helios ZNE Electronic Fan Overrun Timer1 x Transformer 5 Speed Controller - ATC1-10TK1 x Speed Controller - REB31 x Transformer (silent) speed controller - RE 1.5 Amp1 x Elta 2 Amp Electronic single phase speed controller.1 x 110 x 54mm Round to Rectangular Adaptor - Long3 x AXC TP - 150mm Plastic Centrifugal Inline Fan1 x Biflow SB315-CON4-3 - High Temperature Bifurcated Fan1 x Backdraught Shutters 039-SFSV-63/711 x Helios TSW 1.5 Amp Transformer speed controller1 x Control switch - CR1501 x 125mm Round Connector with Damper1 x DDMP 10-10 1F 1000W M6A2 DA51 x RUCK MTP 20, 10K, Speed control1 x Capacitor 2uf for use with the EBM A4E range1 x Elta Variable Speed Drive IP66 - 4.0KW1 x Binks Bullows - Spray Booth Filter1 x Biflow SB250-CON4-3 - High Temperature Bifurcated Fan1 x RR EC 160 Centrifugal inline fan - Energy Efficient Motor1 x Elta Variable Speed Drive IP66 - 2.2KW1 x Round ceiling diffuser 400mm1 x TD Mixvent 1100/250 EEXEIIT31 x REU 3amp Speed control - Two Speed Five-Step Transformer - Trickle and Boost
Reviews
Airvent Ceiling Sweep Fan - 36 inch - 444122
Airvent Ceiling Sweep Fan - 36 inch - 444122
£ 59.84

Fitted 2 Of These Excellent Fans in a Community Club to shif...