• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,438.15 (excl. VAT)

£ 4,125.78 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x CTHB/6-400 High Temp Kitchen Roof Fan1 x Ducting 90 Degree Bend - 250mm1 x Vent Axia SABRE Plate Mounted Sickle Fans - VSP400141 x Heat Resistant In-line Axial Fan - VOK 150/120 H1 x S & P Aluminium Axial Fan Louvre Shutter - PER-CR- 3551 x CTHB/6-2501 x CTHT Kitchen/High Temp Roof Fan - CTHT/8-5001 x Heat Resistant In-line Axial Fan - VOK 135/120 H1 x Heat Resistant In-line Axial Fan - VO-1351 x Elta Raptor SFB ATEX Plate Mounted Axial Fan- 420mm1 x Heat Resistant In-line Axial Fan - VO-1501 x Helios GigaBox 400mm GBW 400/4 T120 centrifugal1 x CTHB/6-2001 x Heat Resistant In-line Axial Fan - VO-1201 x CTHT Kitchen/High Temp Roof Fan- 225mm1 x Ducting 30 Degree Bend - 250mm1 x CTHT Kitchen/High Temp Roof Fan- 250mm1 x HRB/6-630-30-APN1 x Speed Controller - REB11 x Electronic extractor fan speed controller - FSC 1.51 x CBT-130N Centrifugal ATEX II 3D ExtD 125*C1 x TTT/4-800/H N 4KW (400V50HZ)EXEIIT3 VE Atex Unit1 x AXCBF-EX 800-9/18-4 Bifurcated Atex Axial Fans1 x TTT/4-630/H N 1,5KW (230/400V50HZ)EXEIIT3 VE Atex Unit1 x Speed Controller - REB51 x CBT-100 N (230/400V50HZ) LG270-EXDIIBT41 x SAVE VTC 200 L High efficiency Heat Recovery Unit1 x Metal Inline Fan - VENT-150NK1 x CBT-100N Centrifugal ATEX II 2G Exe II T31 x CBT-130N Centrifugal ATEX II 2G Exd IIB T41 x TTT/4-560/L N 0,75KW (230/400V50HZ)EXEIIT3 VE Atex Unit1 x TTT/4-450/H N 0,55KW (230/400V50HZ)EXEIIT3 VE Atex Unit1 x Elta EC Electronic Controller1 x GENIOX 11 Internal Mounted Unit1 x *VORT HRW 30 MONO Evo - Single Room Heat Recovery Unit,1 x HR-500 DP Heat Exchange Unit1 x Acopel F400-400/1601 x Anti Vibration Mounts - Large - Pack of 4 - AVM11 x filter pack (set of 2) pt no. 4438891 x AKOR T3/7 Spare Motor
Reviews
Airvent Ceiling Sweep Fan - 36 inch - 444122
Airvent Ceiling Sweep Fan - 36 inch - 444122
£ 59.84

Fitted 2 Of These Excellent Fans in a Community Club to shif...