• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,610.06 (excl. VAT)

£ 4,332.07 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x Stainless Steel Ducting T Piece - 200mm1 x 400mm 316 Grade stainless steel 90 Bend1 x 316 Grade Stainless Steel Male Connector - 355mm1 x 500mm - 450mm 316 Grade Stainless Steel Ducting Reducer1 x 450mm 316 Grade Stainless Steel 45 Bend1 x Female Ducting Connector - 80mm1 x 300mm 316 Grade Stainless Steel 45 Bend2 x EnergiSava 210 Low Energy Heat Recovery Unit1 x F7/G4 filter kit for IDEO HR unit1 x AKOR Mounting Plate for GD model(VIM166423)1 x 204x60mm x 1000mm Long Hi-Flow Duct Silencer1 x 204x60mm Elbow Bend with 150mm Fixed Spigot1 x AKOR GD - Spare Motor1 x Duct Suspension Rings - 250mm1 x Spiral Ducting 3 Meters - 355mm1 x 204x60mm Equal T Piece1 x Flexible PVC Ducting - 204x601 x Acopel F400-450/1601 x 204x60mm Rectangular to 125mm Round Adaptor1 x Spiral Ducting 1 meter - 355mm1 x 204x60mm x 1m Low Profile Plastic Ducting - 1 Meter1 x AKOR Spare Filter1 x Commercial Thermostat - TH161 x 204x60mm Elbow Bend with 125mm Fixed Spigot1 x GEO Ground Source Heat Exchanger1 x 204x60mm x 2m Low Profile Plastic Ducting - 2 Meter1 x Soler & Palau VFD-T inverter 5 amp IP541 x *VORT HRW 30 MONO Evo HCS WIFI - Single Room Heat Recovery Unit,1 x 204x60mm Double Airbrick Adapter1 x Airbrick Grille with flange - 204 x 60mm1 x 204x60mm Elbow Bend with 100mm Fixed Spigot1 x Ducting 90 Degree Bend - 200mm1 x *VORT HRW 30 MONO Evo - Single Room Heat Recovery Unit,1 x 204x60mm 90 Degree Vertical Bend1 x 204x60mm x 500mm Long Hi-Flow Duct Silencer1 x *VORT HRW 30 MONO Evo HCS - Single Room Heat Recovery Unit,1 x Elta Standard Ambient Flexible Connector - 500mm
Reviews
Transformer (silent) speed controller - RE 1.5 Amp
Transformer (silent) speed controller - RE 1.5 Amp
£ 132.29

Unbelievable! With TDmixvent500: noise reduction minimum 50%...