• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,610.06 (excl. VAT)

£ 4,332.07 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x Transformer 5 Speed Controller - ATC1-10TK1 x ACOAS/ AC/EC Auto Changeover 8Amp2 x ACO8AC/EC AutoChangeover panel1 x TTC-2000 Three phase electric heater controller1 x Elta ACO Panel 149-ACO14E1 x EC-Vent control board1 x EM30-24 Electro-Mechanical Control Panel1 x CONTROL ECOWATT - Basic1 x ACO 149-ACO1/EDV1 x Elta ACO Panel 149-ACO18B1 x Speed Controller - REB52 x Systemair Save Connect 2.0 Internet Module1 x U-EK plastic housing IP65 - for use with the U-EK230E Motor Protection1 x EM30-24 Control Panel Commissioning Service1 x EC-Vent Room Unit1 x Transformer (silent) speed controller - RE 1.5 Amp1 x Egg Crate Grille with G2 Dust panel filter 1 inch- 300x3001 x Egg Crate Grille with Dust panel filter 1 inch- 595x5951 x Single Deflection Grille 400mm with OBD damper1 x Non Vision 150mm x 150mm (Air Transfer) Grille - With Flange - MILL FINISH1 x Mini Diffuser - 100mm1 x Egg Crate Grille with Dust panel filter 1 inch- 300x3001 x Potentiometer EGH 01 - for DDMP Fans1 x STF1 Oscillating Tower Fan1 x Elta SLC560/4C-3AC - IP551 x DDMP 10-10 FLANGE1 x Chaysol Da 12/12 CMAL - 736 Watt - 6 Pole1 x Helios AV125 External Wall Fan1 x EBM-Papst D2E097-BK76-98 Double inlet1 x Transformer 5 Speed Controller - ATC1-4TK1 x Transformer 5 Speed Controller - ATC1-8TK1 x Helios TSW 0.3Amp Compact Transformer speed controller1 x Helios TSW 10 Amp Transformer speed controller1 x RDS 11 Helios Transformer Controller With Motor Protection1 x Helios TSW MCB Amp Transformer speed controller1 x Vent Axia ACM 125 inline mixed flow duct fan1 x CS2 Current Switch1 x TG-K Duct temperature sensor1 x DEF-140T Inlet Guard for the CBT-100N1 x Vent Axia ACM 125 T (Timer Model) inline mixed flow duct fan
BD9/9 centrifugal M4 0.35Kw
BD9/9 centrifugal M4 0.35Kw
£ 399.00 now £ 350.00
Reviews
Transformer (silent) speed controller - RE 1.5 Amp
Transformer (silent) speed controller - RE 1.5 Amp
£ 132.29

Unbelievable! With TDmixvent500: noise reduction minimum 50%...