• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,438.15 (excl. VAT)

£ 4,125.78 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x SAVE VTC 200 L High efficiency Heat Recovery Unit1 x AM pallet Delivery Surcharge1 x SAVE VSR 300 heat recovery unit2 x Genius Whole house unit -1 x IDEO 325 Ecowatt1 x Spare filter for Energi Sava 200 & 250 HR unit1 x Maxi Heat Recovery1 x HR200WK single room heat recovery unit1 x *VORT HRW 30 MONO Evo HCS - Single Room Heat Recovery Unit,1 x Villiavent VTC low Spare Filter Set1 x F7/G4 filter kit for IDEO HR unit1 x 100mm Round 90 Degree Bend1 x AKOR T3/7 Spare Motor1 x SAVE VTC 700 L Heat Recovery Unit1 x Roof Axial Fan and Cowl - Three Phase -350mm1 x GEO Ground Source Heat Exchanger2 x AKOR Spare Filter1 x Ducting T Piece Equal - 250mm2 x MV-Silent 250 Bathroom Extractor Fan Kit - Timer1 x VKS 355-500 Automatic shutter1 x SEL355/2-1AC1 x BDS 630/710 RA b/d shutter1 x JETLINE-250 - In Line Centrifugal Duct Fan1 x Male Ducting Connector - 200mm1 x Acoustic Box Fans (Inline) - CAB-2001 x Soler & Palau TCBB/4-560/L - IP651 x Soler & Palau - HCBT/4-250/H - IP651 x Flanged Spigot - 250mm1 x ELTA - Single Phase Transformer 2amps1 x 100mm Round Equal T Piece1 x CK-60F Kit1 x MV-Silent 250 Bathroom Extractor Fan Kit - Standard - No Timer1 x CADB/T-HE 54 ECOWATT Series1 x Villiavent VTC 700 Spare Filter Set - F7/M5 Grade1 x BDS 400/450 RA b/d shutter2 x GENIOX 11 Internal Mounted Unit1 x Curved boot - 250mm1 x Spiral Duct Grille Termination - 250mm1 x 125mm - 150mm Round Reducer1 x Ancillary Pack for SB-Biflow 250 model1 x 220x90mm x 2m Low Profile Plastic Ducting - 2 Meter1 x Biflow SB250-CON4-1 - High Temperature Bifurcated Fan1 x Anti Vibration Duct Suspension Rings - 250m1 x SAVE VTC 700 R Heat Recovery Unit1 x Duct Quick Suspension Rings with Clasp - 250mm1 x JCA 560 - Back Draft Shutter for CRHB/CRHT Roof Fans1 x Kitchen Extract Grille with Grease Filter and External Wall Fan1 x Spigot plate - 250mm1 x MV-Silent 350 Bathroom Extractor Fan Kit - Standard - No Timer1 x MEV 160 & 300 FT (FastTrack) Additional Spigots1 x Male Ducting Connector - 250mm1 x Helios Condense Collector1 x 400mm x 400mm Metal Grille Box - 250mm Side Entry1 x Backdraught Shutters 039-SFSV-63/711 x Duct Tape - Silver - DTape1 x Ducting 30 Degree Bend - 250mm1 x Elta SLC630/4-1AC - IP551 x Villiavent VSR 300 Spare Motor1 x HRB/6-400-APN
Reviews
Vectaire Elegance Low Energy DMEV Fan Range
Vectaire Elegance Low Energy DMEV Fan Range
£ 119.00

I've had 2 of these fans for 4 years now, and they are great...