• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,438.15 (excl. VAT)

£ 4,125.78 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x Duct Mounted Filter Box - G4 Grade Panel - 355mm1 x KVK SLIM 200 EC - Centrifugal Circular Duct Fan1 x HRFD 250/4 EX Atex Rated 250mm Cased Axial Fan 400v1 x Elta Turboflow-TF - 630mm - Three phase1 x Purlin Box 350 for RAW Cowls1 x Helios GigaBox 560mm GBD 560/4/4 centrifugal1 x Revolution SLCX ATEX Long Cased Axial Flow Fan SLCX400/4-3 Three Phase1 x CBMT/Q 315-30 1 HEATER KIT1 x CFDM-125 Circular Twin Blade Fire Damper1 x Duct Mounted Filter Box - 500mm - M6 grade Bag filter1 x CBMT/Q 150-27 1 HEATER KIT1 x Duct Mounted Filter Box With G2 Paper AND Metal Washable Filter - 400mm1 x Raptor SDA630/4-3EC1 x JAA-560 Acoustic Upstand1 x TCBT/4-450/H EXEIIBT4 ATEX1 x Helios SB-200-C SilentBox Acoustic Inline Fan1 x Activated Carbon Discarb Cell - Grade 50 - EXTRA DUTY - 445H x 445W x 595Dmm ACTUAL1 x Belt Drive Cased Axial Fan - 710mm - H version1 x GENIOX 11 Roof Mounted External Unit1 x Blast Gate (Manual) 100mm1 x Access Door for Circular Duct - 300 x 200 - SIZE 351 x Duct Termination with Mesh - 450mm1 x Elta Wall Cowl SWC45/501 x CFI Lite 600 Carbon Filter1 x HD Series Control Damper - 3000mm X 1500mm1 x Shoed T Piece Un-Equal -450mm-315mm1 x Belt Drive Cased Axial Fan - 630mm - L version1 x Flanged Spigot - 450mm1 x Ducting Y Piece - 100mm1 x *VORT HRW 40 MONO Evo HCS WIFI - Single Room Heat Recovery Unit,1 x Biflow SB250-CON4-1 - High Temperature Bifurcated Fan1 x Miniflow SMF Horizontal Roof Cowl SMF131 x Access Door for Circular Duct - 250 x 150 - SIZE 251 x Soler & Palau - HCBT/4-900/L - IP551 x Access Door for Circular Duct - 300 x 200 - SIZE 401 x Male Ducting Connector - 100mm
Reviews
Airvent Ceiling Sweep Fan - 36 inch - 444122
Airvent Ceiling Sweep Fan - 36 inch - 444122
£ 59.84

Fitted 2 Of These Excellent Fans in a Community Club to shif...