• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,438.15 (excl. VAT)

£ 4,125.78 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x Acoustic Commercial Kitchen Inline Exhaust Fan - MPS (Three Phase) - 400mm1 x Soler & Palau TCBT/6-400/H - IP442 x Anti Vibration Duct Suspension Rings - 160mm1 x Ducting 15 Degree Bend - 500mm1 x *TD EVO-250 - Environmentally Friendly Inline Fan*1 x Clearflow CFHT Kitchen/High Temp Roof Fan - CFHT350/4-3AC1 x Ducting T Piece Equal - 500mm1 x MPC 450 E4 20 - High Temp Acoustic Box Fan1 x Acoustic MiniBox Fan - MINI-BOX 2001 x IK - Inspection Door & Drain Plug for TLZ 450 R1 x Curved boot - 500mm1 x HD Series Control Damper - 2300mm X 1000mm1 x Helios GigaBox 560mm GBD 560/6/6 centrifugal1 x CHVB/4-3000/315 0,27KW 230V50 VE1 x Flanged Spigot - 500mm1 x AL 400 EC 01 AXIALINE - High Performance Long Cased Axial Fan1 x Ducting 45 Degree Bend - 500mm1 x CBM 10/10 4 Pole 550watt RE VR (3 Phase)1 x Ducting 90 Degree Bend - 100mm1 x Helios HQW-450/6 - IP551 x Elta Unpodded Silencer 1D-500mm1 x 220x90mm Insulated Rectangular Horizontal 45° Bend1 x FSAF1250C1DA Silencer 1320/201 x CBMT/Q 125-12 1 HEATER KIT1 x Same Day Shipping Surcharge1 x Biflow SB250-CON2-3 - High Temperature Bifurcated Fan1 x Rectangular Airbrick Adaptor1 x Soler & Palau HXM-200mm1 x Elta SCP450/4-3AC - IP551 x Helios GigaBox 355mm GBW 355/4 centrifugal1 x Ducting T Piece Equal - 560mm1 x Etaline 200mm E2M 01 3-Speed1 x KABT High Temp Acoustic Kitchen Fan & Inverter Kit - KABT/4-9000/500 ND - Pack 41 x 110 x 54mm Elbow Bend Female1 x Helios HRFW 355/4 TK1 x Etaline 355mm - E2-011 x HRB/3-200-BMPN1 x Spigot plate - 560mm1 x Belt Drive Cased Axial Fan - 630mm - H version1 x 220x90mm Insulated Rectangular Vertical 90° Bend1 x Elta LC100N4-A6/381 x Ducting 15 Degree Bend - 100mm1 x 204x60mm x 1m Insulated Rectangular Duct1 x Spiral Ducting 3 Meters - 160mm1 x Belt Drive Cased Axial Fan - 800mm - L version1 x 204 x 60mm Duct to Fitting Connector for use with Insulated Thermal Ducting1 x 110 x 54mm Low Profile Plastic Ducting - 1 Meter1 x Belt Drive Cased Axial Fan - 500mm - L version1 x Helios VARD 355/2/2-TK1 x 110 x 54mm Vertical 90 Degree Bend
Reviews
Circular Inline Silencers - 0.6M long - SLU-600
Circular Inline Silencers - 0.6M long - SLU-600
£ 50.56

I have a loft mount extractor fan which was very noisy. I ...