• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,438.15 (excl. VAT)

£ 4,125.78 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x Cased Axial Fan Extension - 400mm dia1 x Elta Cased Axial Flange - 400mm1 x AW Sileo EC Plate Axial Fan - Three Phase - 1000mm1 x Rosenberg DQ 1000-8 plate axial fan1 x Spiral Ducting 3 Meters - 1000mm1 x Elta Cased Axial Flange - 315mm1 x ASF 355-500 inlet flange DVS1 x KVK Slim 125 - Low profile Semi Acoustic Box Fan1 x Synthetic Air Filter Media - 6mm x 2mtr x 10mtr Half Roll1 x Kitchen Grease Filter - Mesh Type NON standard 390mm x 240mm x 40mm Actual1 x Elta SLC500/2A-3AC - IP551 x Ancillary Pack for SLC-3151 x Synthetic Air Filter Media - 6mm x 2mtr x 5mtr Roll1 x HRB/4-500-35-BPNC1 x Ancillary Pack for SLC-5601 x *VORT HRW 30 MONO Evo HCS WIFI - Single Room Heat Recovery Unit,1 x Ancillary Pack for SB-CYL 400 model1 x Soler & Palau TCBB/4-250/H - IP541 x Helios GigaBox 560mm GBD 560/4/4 centrifugal1 x CBT-125 Centrifugal1 x HV Wall Mounted Belt Drive Fan 1500mm 400V / 50Hz 1.5kW - Three Phase1 x Helios GigaBox 560mm GBD 560/6/6 centrifugal1 x DA 15/15 Feet1 x DA7/9 Feet1 x ERM180EXE Bracket1 x Singleflow SSDL315-1EC1 x *VORT HRW 30 MONO Evo HCS - Single Room Heat Recovery Unit,1 x Ancillary Pack for SLC-900 for SLC900/6A-3AC and SLC900/6B-3AC1 x Soler & Palau - HCBT/4-900/L - IP551 x Soler & Palau - HCBT/6-710/H - IP651 x HIMF - Mixed Flow Fan 150mm Inline Fan1 x CBM 10/10 - 373watt - 6 Pole1 x Soler & Palau TCBB/4-500/H - IP651 x Elta SLC500/4B-1AC - IP551 x Wall Mounted Air Curtains - COR-N Series1 x Elta SPA500/4-1AC - IP541 x GB-WK 250 Wall Bracket For Giga Box Fans - 250mm - 355mm1 x CBM 12/9 750W RE-VR1 x CADB/T-HE 54 ECOWATT Series1 x HQS Bathroom Axial Flow Fan - 125mm1 x CADB/T-HE PRO-REG Series1 x GENIOX 11 Roof Mounted External Unit1 x Raptor SDA560/46-3AC1 x Ancillary Pack for SLC-630
Reviews
Transformer (silent) speed controller - RE 1.5 Amp
Transformer (silent) speed controller - RE 1.5 Amp
£ 125.99

Unbelievable! With TDmixvent500: noise reduction minimum 50%...