• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,438.15 (excl. VAT)

£ 4,125.78 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x Soler & Palau TCBT/4-800/H - IP651 x Classic SAX23/9ARB Wall Mounted1 x Classic SAX23/9A Window/Wall Mounted1 x Gorilla HVLSX501 x Spigot plate - 200mm1 x Singleflow SSDL125-1EC1 x CAB-125 ECOWATT Energy Efficient Acoustic Box Fan1 x KVK SLIM 160 EC - Centrifugal Circular Duct Fan1 x Spiral Duct Grille Termination - 80mm1 x Classic SAX30/12A Window/Wall Mounted1 x Flanged Spigot - 450mm1 x Soler & Palau TCBT/4-800/L - IP651 x Female Ducting Connector - 200mm1 x Elta SLC800/4B-3AC - IP551 x Sentinel D-BOX 150S/CP1 x TD Mixvent 800/200 EEXEIIT31 x CBS-80 Outlet Flange for CBT-801 x Elta SPA630/68-3AC - IP541 x 125mm Round Connector1 x Elta Wall Cowl SWC25/311 x AL 315 EC 01 AXIALINE - High Performance Long Cased Axial Fan1 x Ancillary Sealing Band - 150mm1 x CAB-400 ECOWATT Energy Efficient Acoustic Box Fan1 x Spiral Ducting 3 Meters - 150mm1 x Spiral Ducting 1 meter - 560mm1 x Spiral end cap - 150mm1 x Duct Split Rings (Pair) -560mm1 x GORDON W 30/12″ ET Oscillating wall mounted fan with remote control1 x TD6000 Mixvent - 400mm1 x MV-Silent 250 Bathroom Extractor Fan Kit - Timer1 x Male Ducting Connector - 560mm1 x SWF-150X Sidewall Mounted Extractor Fan1 x Ducting 45 Degree Bend - 180mm1 x DDMP 09/09 Mounting Flange1 x Helios DDF-400 Roof Cowl1 x Impeller Side Guard - 630mm1 x DEF-CBM-RE-7 - Protection Guard1 x MFQ450-14 - SQUARE MIXED FLOW FAN - 450mm Single Phase1 x Impeller Side Guard - 350mm1 x DEF-1000-AN1 x Helios AV125 External Wall Fan1 x Binks Bullows - Spray Booth Filter1 x Ducting T Piece Equal - 560mm1 x Elta Wall Cowl SWC35/401 x MV-Silent 350 Bathroom Extractor Fan Kit - Standard - No Timer
Reviews
EM 250-E2M 01- Etamaster-250
EM 250-E2M 01- Etamaster-250
£ 128.80

Really well made but comes with no speed controler? ?and can...