• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,438.15 (excl. VAT)

£ 4,125.78 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x HCFT/6-1000-HX plastic impeller plate fan1 x Contra Rotating TCBBx2-630 Cased Axial - Single Phase - IP65 - Soler & Palau1 x AIR CONDITIONING UNIT -KYR25CO/AG (Floor Standing)1 x Spiral Ducting 3 Meters - 250mm1 x Helios SB EC 125 A SilentBox Centrifugal Fan1 x Ducted Outlet Option for H14 - HAP5001 x Belt Drive Cased Axial Fan - 630mm - H version1 x Elta Variable Speed Drive IP66 - 0.37KW (1ph to 3ph)1 x AxZent 400 D2 High Temp Kitchen exhaust Fan1 x Ducting T Piece Equal - 80mm1 x HQS Bathroom Axial Flow Fan - 125mm1 x Acoustic Commercial Kitchen Inline Exhaust Fan - MPS (Three Phase) - 250mm1 x ELTA - Single Phase Transformer 10amps1 x Hydor Typhoon Circulation Fans - HVFB - 300mm1 x ELTA - Single Phase Transformer 4amps1 x CHVB/4-3000/315 0,27KW 230V50 VE1 x CAB-125B - High Pressure Acoustic Fan1 x Ducting 90 Degree Bend - 80mm1 x Spiral Duct Grille Termination - 80mm1 x Elta Variable Speed Drive IP66 - 0.75KW1 x Ancillary Pack for SLC-6301 x Kitchen Grease Filter - Mesh Type Non standard 450mm x 150mm x 22mm ( CEF450 Replacement)1 x AKOR GD - Spare Motor1 x Biflow SB250-CON4-1 - High Temperature Bifurcated Fan1 x Soler & Palau - HXTR/12-800/28-A1 x Universal Pipe Fixing Clip1 x HRB/2-200-BPN1 x 100mm Wall Duct - 350mm1 x Spigot plate - 500mm1 x RS-160L1 x Spiral Ducting 3 Meters - 100mm1 x HRST/6-800/28-AQ1 C21 x Inline Axial Fan - VOK-C 3151 x Spiral end cap - 100mm1 x Ancillary Pack for SB-Biflow 315 model1 x DDMP 07/07 Mounting Flange1 x Elta Variable Speed Drive IP66 - 2.2KW (1ph to 3ph)1 x Genius Whole house unit -1 x AKOR T3/7 Spare Motor1 x FU 15 16 Frequency Inverter1 x JETLINE-160 - In Line Centrifugal Duct Fan1 x SPI-250 C Iris damper1 x Elta Variable Speed Drive IP66 - 1.5KW1 x Ducting 90 Degree Bend - 100mm1 x HCFT/6-800-H plastic impeller plate fan1 x Male Ducting Connector - 100mm1 x Belt Drive Cased Axial Fan - 800mm - L version1 x Spigot plate - 100mm1 x SPI-150 C Iris damper1 x GENIOX 11 Internal Mounted Unit
Reviews
Circular Inline Silencers - 0.6M long - SLU-600
Circular Inline Silencers - 0.6M long - SLU-600
£ 50.56

I have a loft mount extractor fan which was very noisy. I ...