• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,438.15 (excl. VAT)

£ 4,125.78 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x Access Door for Circular Duct - 400 x 300 - SIZE 501 x Helios VARW 450/4 - TK1 x Elta SLC450/2A-3AC - IP551 x Floor Standing Cooler Fan- SRC-4501 x Access Door for Circular Duct - 500 x 4001 x Blast Gate (Manual) 300mm1 x HRB/6-400-APN1 x Clearflow CF Roof Mounted Vertical Discharge Centrifugal Fan - CF350/4-3AC - Three Phase1 x Duct Termination with Mesh - 200mm1 x KVK Slim 355 - Low profile Semi Acoustic Box Fan1 x DS-2/2 2-Speed Switch IP54 (Single Phase)1 x Belt Drive Cased Axial Fan - 560mm - H version1 x GB-WSG 355 External Weather Louvers for the Giga-Box Fans - 355mm1 x CADB/T-HE 54 ECOWATT Series1 x CBA-130 Inlet Flange for CBT-1301 x Anti Vibration Duct Suspension Rings - 200mm1 x Axial Roof mounted Extract/Supply Fan- -HCTT/4-1000-A 5.5kw1 x Helios HQW-400/4 - IP551 x Ducting 90 Degree Bend - 160mm1 x KVK Silent 355 Centrifugal circular duct fan1 x HRB/4-400-BPN1 x Circular Ceiling Diffuser - TST 1001 x 150mm Wall Duct - 350mm1 x HXP560/4-3 - 4 Pole - Three Phase1 x CTI CVA-N 500/560 Outdoor cover for CVAB/T Fans1 x AKOR GD - Spare Motor1 x Male Ducting Connector - 200mm1 x Clearflow CF Roof Mounted Vertical Discharge Centrifugal Fan - CF350/4-1AC - Single Phase1 x Flanged Spigot - 200mm1 x ACO3/B Changeover Panel (Three Phase)1 x ILTM-500/560/630 - Motor Cover for ILHT Fans - 51337593001 x FSD-TD 350 x 200 Fire and Smoke Damper, S, EASY FIX AF, GALV Case, GALV Blades, PM230-TF (SC)1 x Elta SPA560/46-3AC - IP541 x FSD-TD 180mm Fire and Smoke Damper, Type C, EASY FIX AF, GALV Case, GALV Blades, PM230-TF (SC)1 x Soler & Palau TCBT/4-560/H - IP651 x Elta Turboflow-TF - 560mm - Three phase1 x Soler & Palau - HCBB/6-560/H - IP651 x HR-500 DP Heat Exchange Unit1 x Spigot plate - 200mm1 x Soler & Palau - HXTR/4-560/H - IP54
Reviews
EM 250-E2M 01- Etamaster-250
EM 250-E2M 01- Etamaster-250
£ 128.80

Really well made but comes with no speed controler? ?and can...