• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,438.15 (excl. VAT)

£ 4,125.78 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x Spigot plate - 315mm1 x Speed Controller - REB161 x HCFT/4-315mm plastic impeller plate fan1 x REU 1.5amp Speed control - Two Speed Five-Step Transformer - Trickle and Boost1 x Helios GigaBox 500mm GBD 500/4/4 centrifugal1 x Elta SLC1000/6A-3AC - IP551 x VKS 355-500 Automatic shutter1 x BDS 500/560 RA b/d shutter1 x Helios Condense Collector1 x Transformer speed controller - ATC1 - 1.5 Amps1 x COM-31 x BDS 630/710 RA b/d shutter1 x Duct Suspension Rings - 315mm1 x Duct Quick Suspension Rings with Clasp - 315mm1 x Temperature Fan Speed Controller - ATCP4-FLS1 x Transformer (silent) speed controller - RE 1.5 Amp1 x AL 1000 D4 02 - High Performance Long Cased Axial Fan1 x Spiral Ducting 1 meter - 630mm1 x Duct Split Rings (Pair) -630mm1 x CPTA-E Flush mounted PIR sensor with timer1 x Elta SPA350/4-1AC - IP441 x FAST-TRACK RANGE 75mm - Semi-Rigid Duct 50M1 x Duct Humidistat - HS4_hdt1 x Differential Pressure Switch - 20 - 300 Pa - IP541 x Soler & Palau - HXTR/4-355/H - IP541 x Purlin Box 200/250 for RAW Cowls1 x DryFan 8 - DH800 8 Litre Desiccant Dehumidifier1 x HQD 355/4 Plate Axial Fan (4-pole)1 x Ancillary Pack for SB-Biflow 250 model1 x Soler & Palau - HCBB/2-355/H - IP651 x 3 in 1 Portable Air Conditioner - 1500w1 x CBT-100 N (230/400V50HZ) LG270-EXDIIBT41 x Raptor SDA500/4-1AC1 x Elta Turboflow-TF - 500mm - Single phase1 x Hydor HPA315/4-1A1 x EC Trickle and boost module - IP561 x DT-1 Duct Mounted Thermostat1 x Duct Clamps box of 50 - 60mm - 270mm1 x Duct Humidistat - HS3_hdt1 x Elta SCP350/4-1AC - IP551 x Metallic Kitchen Extractor - CK35N
Reviews
DAOSL Back Draft Damper
DAOSL Back Draft Damper
£ 10.53

Look good, works well, except the shaft of the lanellae cuts...