• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,438.15 (excl. VAT)

£ 4,125.78 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x Gripple HVAC Hanger Range - Loop Fast - LF2 - 3mtr1 x EBB-175 S DESIGN Centrifugal Extractor Fan1 x Metallic Kitchen Extractor - CK35N1 x EB-100N S - Centrifugal Fan1 x Elta SPA500/6-1AC - IP541 x HCFT/4-5001 x EBB-250 M DESIGN Centrifugal Extractor Fan1 x ECO-500 Kitchen Extract Fan1 x Bathroom Fan -Envirovent- Silent 100 S (Standard Model)1 x Revolution SLCX ATEX Long Cased Axial Flow Fan SLCX630/4-3 Three Phase1 x Helios AV150 External Wall Fan1 x Acopel F400-250/1601 x Revolution SLCX ATEX Long Cased Axial Flow Fan SLCX355/4-3 Three Phase1 x Revolution SLCX ATEX Long Cased Axial Flow Fan SLCX400/4-3 Three Phase1 x Belt Drive Cased Axial Fan - 630mm - H version1 x Capacitor 6uf for use with the EBM D4E range1 x Elta HXP 800mm 6-Pole (Three Phase)1 x HV STYLVENT Wall Kit Threaded Rods1 x FlameProof Plate Axial Fan - Single Phase - 12 inches - Eexd IIC T4 -4pole1 x FlameProof Plate Axial Fan - Single Phase - 9 inches - Eexd IIC T4 -2pole1 x Elta Raptor SFB ATEX Plate Mounted Axial Fan- 420mm1 x Soler & Palau TCBB/6-630/L - IP651 x Ancillary Sealing Band - 200mm1 x 400mm x 400mm Metal Grille Box - 250mm Side Entry1 x Helios GigaBox 315mm GBW 315/4 centrifugal1 x CBMT/Q 400-9 3 HEATER KIT1 x HRFD 250/4 EX Atex Rated 250mm Cased Axial Fan 400v1 x 7-Day Digital Time Switch - TCK7D-6A1 x Elta Variable Speed Drive IP66 - 1.5KW (1ph to 3ph)1 x CBMT/Q 315-120 3 HEATER KIT1 x Soler & Palau TCBB/4-630/L - IP651 x Compact SCD630/4-3AC1 x Acopel F400-180/1601 x HV Wall Mounted Belt Drive Fan 1250mm 220V to 240V / 50Hz 1.1kW - Single Phase1 x DV-ROF-V-315 Roof mounted unit1 x Airvent ceiling fan controller1 x Isolator Relay Controller - 4420301 x CBMT/Q 125-12 1 HEATER KIT1 x Spiral Duct Grille Termination - 500mm1 x Electronic extractor fan speed controller - FSC 1.51 x Gorilla HVLSX501 x Elta Turboflow-TF - 630mm - Single phase1 x Duct Termination with Mesh - 500mm1 x DOL Starter with Isolator - Three phase1 x Capacitor 4uf for use with the EBM A2E range1 x FlameProof Plate Axial Fan - Single Phase - 15 inches - Eexd IIC T4 -4pole1 x Classic SAX30/12ARB Wall Mounted1 x Ducting 30 Degree Bend - 200mm1 x FlameProof Plate Axial Fan - Single Phase - 9 inches - Eexd IIC T4 -4pole1 x Classic SAX23/9A Window/Wall Mounted1 x Spiral Ducting 3 Meters - 630mm1 x Elta 3 Amp Electronic single phase speed controller.1 x HCFT/4-800mm plastic impeller plate fan1 x Revolution SLCX ATEX Long Cased Axial Flow Fan SLCX450/4-3B Three Phase1 x Elta 2 Amp Electronic single phase speed controller.1 x Acopel F400-355/160
Air Quality Sensor - AQS
Air Quality Sensor - AQS
£ 98.29 now £ 65.00
Reviews
Circular Inline Silencers - 0.6M long - SLU-600
Circular Inline Silencers - 0.6M long - SLU-600
£ 50.56

I have a loft mount extractor fan which was very noisy. I ...