• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,438.15 (excl. VAT)

£ 4,125.78 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x AMD 400/2/2 High Pressure Long Cased Axial Fan1 x Ducting 45 Degree Bend - 355mm1 x Spiral Duct Grille Termination - 355mm1 x Duct Humidistat - HS3_hdt1 x Ancillary Pack for SB-CYL 630 model1 x Ancillary Pack for SB-CYL 500 model1 x Male Ducting Connector - 355mm1 x 110 x 54mm Short Rectangular to Round Adaptor male1 x Air Quality Sensor - AQS1 x Hydor HPA315/4-1A1 x EuroSeries (ESP) - Plate Mounted Axial Fans 315-121 x CPTA-E Flush mounted PIR sensor with timer1 x HPA Heavy Duty Flexible Ducting1 x Soler & Palau TCBT/6-400/H - IP441 x PBT/4-400 Portable Cooling Fan1 x CRBB/4-400/J ML UL1 x Mini Diffuser - 100mm1 x Flanged Spigot - 355mm1 x 110 x 54mm Short Rectangular to Round Adaptor Female1 x Ancillary Pack for SLC-710 for 4 pole Motors1 x Economy Airvent 150mm Fan1 x 100mm Round Wall Plate1 x CS2 Current Switch1 x Universal Pipe Fixing Clip1 x IBC - Plastic Container 1000l1 x Ancillary Pack for SLC-900 for SLC900/6A-3AC and SLC900/6B-3AC1 x 100mm Round Connector1 x SEL355/2-1AC1 x Spiral Ducting 3 Meters - 355mm1 x 18M - 80mm PVC flexible ducting1 x Ancillary Pack for SLC-900 for SLC900/4A-3AC and SLC900/8-3AC1 x 204 x 60mm Duct to Fitting Connector for use with Insulated Thermal Ducting1 x FAST-TRACK RANGE 90mm - Semi-Rigid Duct 50M1 x Ancillary Pack for SLC-6301 x Raptor SDA400/4-1AC1 x Duct Fast Clamps - 355mm1 x Differential Pressure Switch - 50 - 500 Pa - IP651 x ARIETT I - Centrifugal Bathroom Fan1 x EBB-250 M DESIGN Centrifugal Extractor Fan1 x Galvanised Banding1 x Elta - SMT 125 Mixvent Inline Fan - Clearance Stock Line1 x AL 315 EC 01 AXIALINE - High Performance Long Cased Axial Fan1 x Decor 300-CRZ Bathroom Fan1 x Belt Drive Cased Axial Fan - 800mm - H version1 x Centrif Duo Plus - Timer1 x Elta SCP350/4-1AC - IP551 x Elta Variable Speed Drive IP66 - 1.5KW1 x Elta Variable Speed Drive IP66 - 2.2KW (1ph to 3ph)1 x HRFD 250/4 EX Atex Rated 250mm Cased Axial Fan 400v1 x S & P Aluminium Axial Fan Louvre Shutter - PER-CR- 4501 x Ancillary Pack for SLC-4001 x Inclined Curb support BI-3 for TH-5001 x Revolution SLCX ATEX Long Cased Axial Flow Fan SLCX630/4-3 Three Phase1 x GB-WSD 560 Weather Protection hood for the Giga-Box Fans - 560mm1 x Spiral Ducting 3 Meters - 160mm1 x Revolution SLCX ATEX Long Cased Axial Flow Fan SLCX560/4-3 Three Phase1 x Elta SLC315/4-3AC - IP551 x Round ceiling diffuser 350mm1 x 110 x 54mm Elbow Bend Male1 x Purlin Box 500/560 for RAW Cowls1 x Soler & Palau - HXBR/4-355/H - IP541 x Soler & Palau TCBT/6-800/L - IP651 x FRQ5-10A Inverter Speed controller1 x HRT/4-355-BPN1 x filter pack (set of 2) pt no. 4438891 x Elta Variable Speed Drive IP66 - 5.5KW1 x Soler & Palau TCBT/4-315/H - IP441 x Round ceiling diffuser 400mm1 x Metallic Kitchen Extractor - CK35N1 x Purlin Box 300/315 for RAW Cowls1 x *VORT HRW 30 MONO Evo - Single Room Heat Recovery Unit,1 x Helios AV200 External Wall Fan1 x Circular Ceiling Diffuser - TST 2001 x GB-WSG 355 External Weather Louvers for the Giga-Box Fans - 355mm
Reviews
Transformer (silent) speed controller - RE 1.5 Amp
Transformer (silent) speed controller - RE 1.5 Amp
£ 125.99

Unbelievable! With TDmixvent500: noise reduction minimum 50%...