• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,438.15 (excl. VAT)

£ 4,125.78 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x Gorilla HVLSX701 x Soler & Palau TCBB/4-250/H - IP541 x Gorilla HVLSX401 x Atex Inline Fan 180mm - ERM18EXE1 x Ducting 90 Degree Bend - 500mm1 x Duct Split Rings (Pair) -560mm1 x Envirovent Silent MV160/100S Mixvent - 100mm - (5 year warranty)1 x Female Ducting Connector - 560mm1 x Gorilla HVLSX501 x Classic SAX30/12AR Window/Wall Mounted1 x Shoed T Piece Equal - 560mm1 x TD Mixvent 800/200 EEXEIIT31 x Impeller Side Guard - 900mm1 x Spigot plate - 160mm1 x 204 x 60mm Duct to Duct Connector for use with Insulated Thermal Ducting1 x Compact SCD500/4-3AC1 x Ducting T Piece Equal - 315mm1 x Female Ducting Connector - 355mm1 x Ducting Y Piece - 355mm1 x Hydor Typhoon Circulation Fans - HVFB - 450mm1 x Spiral Duct Grille Termination - 355mm1 x FSD-TD 200mm Fire and Smoke Damper, Type C, EASY FIX AF, GALV Case, GALV Blades, PM230-TF (SC)1 x FSD-TD 400 x 200 Fire and Smoke Damper, S, EASY FIX AF, GALV Case, GALV Blades, PM230-TF (SC)1 x GX6EC - High Performance Extract Fan1 x Acoustic Box Fans (Inline) - CAB-1601 x Female Ducting Connector - 800mm1 x 400mm 304 stainless steel 90 Bend1 x Anti Vibration Duct Suspension Rings - 400mm1 x Flanged Spigot - 80mm1 x BKF 800D6-XL/F400 IE3 - Centrifugal rectangular duct fan 400C/2h1 x Airvent ceiling fan controller1 x Duct Termination with Mesh - 800mm1 x Impeller Side Guard - 630mm1 x 110 x 54mm Short Rectangular to Round Adaptor male1 x Raptor SDA500/4-3EC1 x 125mm Wall Duct - 350mm1 x Impeller Side Guard - 315mm1 x Raptor SDA500/4-1AC1 x Spiral Ducting 1 meter - 160mm1 x DEF-140T Inlet Guard for the CBT-100N1 x CBB-100N Centrifugal1 x Ducting 30 Degree Bend - 400mm1 x Impeller Side Guard - 450mm1 x HCFC 1.7 - Reversible Speed Controller for HCF sweep fans1 x Spiral end cap - 150mm1 x FSD-TD 350 x 200 Fire and Smoke Damper, S, EASY FIX AF, GALV Case, GALV Blades, PM230-TF (SC)1 x Ducting Y Piece - 315mm1 x Spiral Ducting 3 Meters - 125mm1 x Elta SLC500/4A-3AC - IP551 x Anti Vibration Duct Suspension Rings - 315mm1 x Spiral Ducting 3 Meters - 400mm1 x Elta Turboflow-TF - 500mm(A) - Three phase1 x FSD-TD 150mm Fire and Smoke Damper, Type C, EASY FIX AF, GALV Case, GALV Blades, PM230-TF (SC)1 x FSD-TD 350mm Fire and Smoke Damper, Type C, EASY FIX AF, GALV Case, GALV Blades, PM230-TF (SC)
Air Quality Sensor - AQS
Air Quality Sensor - AQS
£ 98.29 now £ 65.00
Reviews
Duct Mounted Inline Filter - EU4
Duct Mounted Inline Filter - EU4
£ 41.95

Well made and robust, but it was not use for my application ...