• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,438.15 (excl. VAT)

£ 4,125.78 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x PVO 200 (2-POLE) Plate Axial fan1 x Elta Turboflow-TF - 500mm - Single phase1 x Elta SCP710/4/6-3AC - IP551 x GORDON W 30/12″ ET Oscillating wall mounted fan with remote control1 x Euro Series - Case Axial - ESC500141 x HRST/4-710-20 BPN C Rotorex Sickle bladed fan1 x EBB-250 S DESIGN Centrifugal Extractor Fan1 x Raptor SDA500/6-1AC1 x Helios HRFW 500/41 x HRT/6-710/30-BQ E21 x Dynair QCL 200mm (2-Pole)1 x Stainless Steel Single Blade Regulating Damper -150mm1 x CBM Low Pressure Centrifugal Fan - CBM 12/12 6 Pole 515watt VR RE1 x Elta - SMT 125 Mixvent Inline Fan - Clearance Stock Line1 x HIMF - Mixed Flow Fan 150mm Inline Fan1 x Economy Airvent 150mm Fan1 x Etaline 355mm - E2-011 x Jetflow-HIT Metal inline - 125mm1 x Elta ACO Panel 149-ACO14E1 x K 315 L Sileo Metal Tube Fan1 x EM30-24 Control Panel Commissioning Service1 x Elta SLC560-1EC -IE5 Motor- IP551 x Soler & Palau TCBT/4-560/H - IP651 x 204x60mm Flat Channel Connector1 x Raptor SDA560/6-1AC1 x Soler & Palau TCBT/4-710/L - IP651 x 204x60mm x 500mm Long Hi-Flow Duct Silencer1 x Commercial Activated Carbon Filters - Panel Type - 24" x 24" x 2" - ACP1 x CC-710-2.2kw1 x S & P Aluminium Axial Fan Louvre Shutter - PER-CR- 5001 x Elta SCP630/4-1AC - IP551 x Metal Inline Fan - VENT-400K - T (3 Phase)1 x CBMT/Q 400-9 3 HEATER KIT1 x FSD-TD 350mm Fire and Smoke Damper, Type C, EASY FIX AF, GALV Case, GALV Blades, PM230-TF (SC)1 x AKOR Spare Filter1 x Ducting 90 Degree Bend - 400mm1 x TD1300 Mixvent - 250mm1 x Etamaster EM 250 EC 02 (high Power) inline mix-vent fan1 x Elta SCP400-1EC - IP551 x CBB-80N Centrifugal
Reviews
Transformer (silent) speed controller - RE 1.5 Amp
Transformer (silent) speed controller - RE 1.5 Amp
£ 125.99

Incredible, Perfect, Silent and Fast delivery ! Thanks "Just...