• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,438.15 (excl. VAT)

£ 4,125.78 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x HRT/4-355-BPN1 x Elta Standard Ambient Flexible Connector - 315mm1 x Northern Ireland Surcharge1 x Acopel F400-180/1601 x FedEx TEN AM delivery Surcharge1 x Acopel F400-120/1601 x Elta Standard Ambient Flexible Connector - 1000mm1 x Soler & Palau - HCBB/6-355/H - IP651 x Additional shipping charge for offshore islands1 x Same Day Shipping Surcharge1 x HRST/6-910/30-BZ1 x Elta Unpodded Silencer 1D-560mm1 x External weather louvre 250mm x 250mm in RAL 70211 x Quietflow SQS500-1ECL - Centrifugal Box Fan1 x EnergiSava 210 Low Energy Heat Recovery Unit1 x 125mm Thermal Duct to Fitting Connector - SST-125-DFCON1 x Elta SLC800/4A - Fan & Inverter Package1 x Elta 6 Amp Electronic single phase speed controller with TK1 x KVK Silent 355 Centrifugal circular duct fan1 x ELTA - Single Phase Transformer 10amps1 x Elta Variable Speed Drive IP66 - 1.5KW (1ph to 3ph)1 x Belt Drive Cased Axial Fan - 800mm - L version1 x GENIOX 11 Roof Mounted External Unit1 x Systemair AR 200E2 Sileo - IP441 x GRA-100 External Grill by S&P1 x Flanged Spigot - 80mm1 x Elta 3 Amp Electronic single phase speed controller with TK1 x Soler & Palau TCBT/6-800/H - IP651 x Gripple HVAC Hanger Range - Loop Fast - LF1 - 1mtr1 x KVK Slim 500 - Low profile Semi Acoustic Box Fan1 x GB-WSG 450 External Weather Louvers for the Giga-Box Fans - 450mm1 x CTI CVA-N 250/315 Outdoor cover for CVAB/T Fans1 x EC6H - Reversible Group Fan Electronic Controller1 x ELTA - Single Phase Transformer 16amps1 x AKOR GD - Spare Motor1 x filter pack (set of 2) pt no. 4438891 x M8 x 3M Z/P Studding
Reviews
Circular Inline Silencers - 0.6M long - SLU-600
Circular Inline Silencers - 0.6M long - SLU-600
£ 50.56

I have a loft mount extractor fan which was very noisy. I ...