• Model:PULS-TC

Pulser Temperature control

£ 125.72 (excl. VAT)

£ 150.86 (inc. VAT)

Pulser Temperature control
Electronic temperature control

The Pulser is a single or two-phase temperature regulator for controlling heater batteries.

This device is connected in series between the mains and an electric heater. The Pulser has an integral regulator with an input terminal for a duct temperature sensor which is located in the supply air duct.
The integral sensor can be used when regulating room temperature. The power regulation is completely stepless thanks to what is known as time-proportional control, which means that the relationship between the on' and off' times is determined by the set temperature requirement. The total on' and off' time, or pulse period, is approximately 1 minute.
1 x Elta 10 Amp Electronic single phase speed controller.1 x ELTA - Single Phase Transformer 2amps1 x Electronic extractor fan speed controller - FSC 1.51 x Elta 2 Amp Electronic single phase speed controller.2 x Elta 3 Amp Electronic single phase speed controller with TK1 x ELTA - Single Phase Transformer 16amps1 x ELTA - Single Phase Transformer 8amps1 x 5-Speed Controller for use with Elta SAX Classic Fans1 x Elta 3 Amp Electronic single phase speed controller.1 x Elta 6 Amp Electronic single phase speed controller with TK1 x EFSC-3N- Single Phase Speed Control1 x Airvent ceiling fan controller1 x ELTA - Single Phase Transformer 12amps1 x AIRVENT speed control - AIR4019611 x ELTA - Single Phase Transformer 4amps1 x EFSC-6N- Single Phase Speed Control1 x ELTA - Single Phase Transformer 10amps1 x Run On Timer - 5s - 4hrs - RT5A2 x Push Timer Switch - ZA41 x Helios ZNE Electronic Fan Overrun Timer2 x Multi Input Run On Timer - 0 - 20min - CFCU1 x Time Delay Unit - DT20B1 x 7 Day Programmable TIMECLOCK1 x HCFC 1.7 - Reversible Speed Controller for HCF sweep fans1 x Vent Axia ACM 150 inline mixed flow duct fan1 x TTC-2000 Three phase electric heater controller1 x Elta ACO Panel 149-ACO14E1 x CONTROL ECOWATT - Basic1 x EC-Vent control board1 x ACO 149-ACO1/EDV1 x CPTA-S PIR SENSOR Volt Free Contacts - Surface Mounted1 x KMBI 225 Connector rectangular/circular to install on the discharge of CMT2 x Helios TSW 3 Amp Transformer speed controller1 x Vent Axia ACM 100 inline mixed flow duct fan1 x CS2 Current Switch
Reviews
DAOSL Back Draft Damper
DAOSL Back Draft Damper
£ 11.49

Look good, works well, except the shaft of the lanellae cuts...