100mm Stainless Steel 15 Bend
Manufacture spiral, bends, tees and everything else out of 304 and 316 Grade stainless with the 2B finish.
All of our stainless spiral and fittings are manufactu...
This kit consists of original high quality filters for the ventilation unit SAVE VTR 300.
1x Supply Air Bag filter.
1x Extract Air Bag filter.
Please refer to the data sheet for further specifi...
This is a range of fully flexible thermally insulated ducting, which has been specially designed for the HVAC market. It has been developed to minimise the heat gain or loss resulting from the tempera...
The RT5A is a multi-range run-on timer with time delay adjustment from 5 seconds to 4 hours. Time ranges are set by means of the internal DIL switches and delay time can be set with a small screwdrive...
Differential Pressure Switch - FPS1 - working range - 50 - 500 Pa - IP54
Differential pressure switch for air and non-corrosive gasses, these highly sensitive air differential pressure switches are...
Impeller Side Guard - 630mm
Powder Coated Polyester Paint finish in RAL 7040
Fixing Clips and Screws Provided
Designed to fit all Elta plate and cased axial fans....
400mm Ducting Unequal T-Piece
Similar to a normal T-Piece except the branch is smaller than the main duct (400mm).
These are normally made to order.
Select middle spigot size below.
Please ask for...
An ATEX rated inline fan for explosive atmospheres, such as paint spray booths, thinners extraction and any other use involving explosive substances.
Used in conjunction with ducting, (200mm).
...
Elta 2 Amp Electronic single phase speed controller 149-EL31.
Suitable for a range of Elta products and others.
Stepless speed control allows precise fan speed selection.
IP51 enclosure
Minimum a...
The SPI is an iris damper for measuring and adjusting the air flow. The SPI has the following specifications: low noise level, centrically-formed air flow and fixed test points for precise measurement...
450mm Spiral end cap.
Up to 450mm they are both male and female for flexibility.
The male end will insert into spiral ducting, the female end will go over spigots or fittings....