500mm Spiral

500mm Curved boot Supplied with 500mm spigot....

500mm Duct split rings for solid or semi flexible ducting, Can be used to hang from a ceiling or mount onto the wall securing the ducting in place....

500mm Angled exhaust take-off (with bird mesh) at 45 Degrees, designed for terminating round ducts. Also known as Birdbeaks....

Ducting 15 Degree bend, fabricated and without gasket....

500mm Ducting 45 Degree fabricated bend, seam-welded and calibrated, without gasket....

Ducting 60 Degree fabricated, without gasket....

500mm Ducting 90 Degree fabricated bend, without gasket....

Long Reducers for 500mm spiral ducting. Provides two male fittings to insert into spiral. Select size below. Please note these are for reducing and fitting inside ducting. To mount directly onto a ...

500mm Ducting Equal T-Piece Vent tee piece built with a saddle or a fully pressed top section, all connections the same size....

500mm Ducting Unequal T-Piece Similar to a normal T-Piece except the branch is smaller than the main duct (500mm). These are normally made to order. Select middle spigot size below. Please ask for...

500mm Ducting Equal Y-Piece Galvanised Y Joiner Ducting Fixture....

A 500mm Female coupling connector for joining fittings together or to a fan unit. To Join two pieces of ducting together, you will need the CONM - Male Ducting Connector...

A 500mm Spigot ring or take-off vent, without radius and gaskets, for connecting to ducting. Provides a male ducting connection so inserts into spiral. Designed for installation in the walls of rect...

A 500mm male coupling connector for joining two pieces of ductwork together. Can also be used with hose clips to join lengths of flexible ducting....

Pressed ducting saddle to fit 500mm Spiral ducting, without gasket. Select take-off size below. ...

Connects a duct to a wall face or rectangular ductwork, provides a 500mm male spigot surrounded by a 600mm square plate of steel....

500mm EPNF Spiral Duct Termination Grills are female-ended fittings to be inserted directly onto round Spiral ducts. The 12.7x12.7mm mesh installed at the termination end secures the air exhaust aga...

500mm Zinc-plated Mild Steel Spiral Tube used for ventilation systems. Spiral ducting is manufactured 0.6mm of Zinc-plated Mild steel to HVCA DW 144 Specification unless otherwise stated. An alterna...

500mm Zinc-plated Mild Steel Spiral Tube used for ventilation systems. Spiral ducting is manufactured 0.6mm of Zinc-plated Mild steel to HVCA DW 144 specification unless otherwise stated. An alt...

500mm Spiral end cap. Up to 315mm they are both male and female for flexibility. The male end will insert into spiral ducting, the female end will go over spigots or fittings....