560mm Spiral

560mm Shoed Equal T-Piece 560-560-560mm Galvanised T Joiner Ducting Fixture. These are made to order and can take up to 2 weeks to fabricate....

560mm Ducting 15 Degree fabricated, without gasket....

560mm Zinc-plated Mild Steel Spiral Tube used for ventilation systems. Spiral ducting is manufactured 0.6mm of Zinc-plated Mild steel to HVCA DW 144 specification unless otherwise stated. An alt...

560mm Ducting 90 Degree fabricated bend, without gasket....

A 560mm Female coupling connector for joining fittings together or to a fan unit. To Join two pieces of ducting together, you will need the CONM - Male Ducting Connector...

A 560mm male coupling connector for joining two pieces of ductwork together. Can also be used with hose clips to join lengths of flexible ducting....

560mm Ducting Equal T-Piece Vent tee piece built with a saddle or a fully pressed top section, all connections the same size....

560mm Angled exhaust take-off (with bird mesh) at 45 Degrees, designed for terminating round ducts. Also known as Birdbeaks....

A 560mm Spigot ring or take-off vent, without radius and gaskets, for connecting to ducting. Provides a male ducting connection so inserts into spiral. Designed for installation in the walls of rect...

560mm Ducting 45 Degree fabricated bend, seam-welded and calibrated, without gasket....

560mm EPNF Spiral Duct Termination Grills are female-ended fittings to be inserted directly onto round Spiral ducts. The 12.7x12.7mm mesh installed at the termination end secures the air exhaust aga...

Connects a duct to a wall face or rectangular ductwork, provides a 560mm male spigot surrounded by a s650mm quare plate of steel....

560mm Zinc-plated Mild Steel Spiral Tube used for ventilation systems. Spiral ducting is manufactured 0.6mm of Zinc-plated Mild steel to HVCA DW 144 Specification unless otherwise stated. An alterna...

Long Reducers for 560mm spiral ducting. Provides two male fittings to insert into spiral. Select size below. Please note these are for reducing and fitting inside ducting. To mount directly onto a ...

560mm Ducting Unequal T-Piece Similar to a normal T-Piece except the branch is smaller than the main duct (560mm). These are normally made to order. Select middle spigot size below. Please ask for...

560mm Duct split rings for solid or semi flexible ducting, Can be used to hang from a ceiling or mount onto the wall securing the ducting in place....

560mm Curved boot Comes with 450mm spigot...