• Model:EFSC0/10

0-10v Fan Speed Controller - EFSC 0/10

£ 119.94 (excl. VAT)

£ 143.93 (inc. VAT)

The EFSC 0/10 is a 240-volt Fan Speed Controller available in either 6.0 or 10.0Amp; suitable for 2 or 3 wire control of single-phase speed controllable motors. The unit can be controlled from a remote 0-10 volt dc input voltage (from a BMS system or sensor). Alternatively the control could be from a remote 10k potentiometer. The controller can be switched on and off with a remote volt free switch, this remote switch would operate a power relay within the controller breakingthe incoming live supply. The unit is housed in a plain grey ABS plastic enclosure. This model is fully suppressed to EN55014 and is also suitable for resistive lighting loads.

Specification
• Supply: 220-250V 1PH 50/60Hz
• Output load: 6 amps or 10 amps max (fan loads or resistive lighting loads)
• DC Input: 0-10V dc (0V in=min level out, 10V in=240V out)
• Input impedance: 100K
• EMC suppressed to EN55014
• Enclosure: grey ABS (200mm x 155mm x 80mm)
PDF Files


Data Sheet

Available Options

1 x Commercial Activated Carbon Filters - Panel Type - 24" x 24" x 2" - ACP1 x Activated Carbon Discarb Cell - 293H x 293W x 598Dmm1 x Ducting T Piece Equal - 100mm1 x 150mm - 100mm Round Reducer1 x Spiral Ducting 3 Meters - 80mm1 x 204x60mm to 125mm Insulated Straight Adapter1 x Female Ducting Connector - 150mm1 x Duct Wrap Insulation - AWDW25mm1 x Ancillary Pack for SB-Biflow 400 model1 x Ancillary Pack for SB-CYL 400 model1 x Access Door for Circular Duct - 300 x 200 - SIZE 502 x Elta SCP800/6/8-3AC - IP551 x 150mm Round Connector2 x 100mm - 125mm Round Reducer1 x Blast Gate (Manual) 125mm1 x Flanged Spigot - 80mm1 x 220x90mm Flat Channel Connector1 x Ducting Y Piece - 200mm1 x Spiral end cap - 250mm2 x Access Door for Circular Duct - 400 x 300 - SIZE 631 x Flanged Spigot - 100mm1 x 110 x 54mm Horizontal 45 Degree Bend1 x Access Door for Circular Duct - 250 x 150 - SIZE 251 x Female Ducting Connector - 315mm1 x Access Door for Circular Duct - 400 x 300 - SIZE 561 x Access Door for Circular Duct - 250 x 150 - SIZE 151 x HCFT/4-800mm plastic impeller plate fan1 x Access Door for Circular Duct - 300 x 200 - SIZE 401 x ACCESS DOOR FOR CIRCULAR DUCT 180 X 180 -- 100/1251 x 125mm Round Connector with Damper1 x 100mm Round Connector1 x Spiral Ducting 1 meter - 150mm1 x Duct Suspension Rings - 100mm1 x Vent Axia ACM 150 T (Timer Model) inline mixed flow duct fan1 x G2 duct mounted panel filter 100-1601 x HV Wall Mounted Belt Drive Fan 800mm 400V / 50Hz 0.75kW - Three Phase2 x Soler & Palau - HXTR/6-800/H - IP541 x Blast Gate (Manual) 180mm1 x 125mm Wall Duct - 350mm1 x Anti Vibration Duct Suspension Rings - 125mm1 x 110 x 54mm Rectangular Wall Plate1 x Spiral end cap - 125mm1 x Envirovent Silent MV160/100S Mixvent - 100mm - (5 year warranty)1 x Soler & Palau - HCBT/4-800/H-B FLOW ( Supply Air Fan) - IP551 x Soler & Palau VFD-M inverter 10 amp IP541 x *VORT HRW 30 MONO Evo HCS WIFI - Single Room Heat Recovery Unit,1 x Ducting 90 Degree Bend - 100mm1 x *TD EVO-100 - Environmentally Friendly Inline Fan*1 x MV-Silent 350 Bathroom Extractor Fan Kit - Timer1 x Duct Termination with Mesh - 150mm1 x 204x60mm x 1m Insulated Rectangular Duct1 x HCFT/6-800-H plastic impeller plate fan1 x Activated Carbon Discarb Cell - Grade 50 - EXTRA DUTY - 445H x 445W x 595Dmm ACTUAL1 x Soler & Palau - HCBT/4-800/L-AX - IP551 x *NEW* TD EVO-200 PF ECOWATT - Environmentally Friendly Energy Efficient Inline Fan2 x Soler & Palau - HCBT/4-800/H - IP551 x Ducting 45 Degree Bend - 100mm1 x *VORT HRW 30 MONO Evo - Single Room Heat Recovery Unit,1 x *VORT HRW 30 MONO Evo HCS - Single Room Heat Recovery Unit,
Reviews
DAOSL Back Draft Damper
DAOSL Back Draft Damper
£ 10.53

Look good, works well, except the shaft of the lanellae cuts...