• Model:ERM18EXE

Atex Inline Fan 180mm - ERM18EXE

£ 892.50 (excl. VAT)

£ 1,071.00 (inc. VAT)

Product description
* For commercial use: Durable, powerful and robust.
* Type-examination tested according to European Directive 94/9/EC (ATEX).
* Device group II, Category 2 G
* Type of protection "e": Increased safety
* For zones 1 and 2.
* For ventilation or air extraction, depending on the installation direction.
* Can be fitted in any position.
* Balanced safety technology available.
* 310m3/hr this version
Features
* MAICO Ex fans fulfil the safety requirements of European Directive 94/9/EC for units and protective systems in explosion-endangered areas.
* Device group II, Category 2 G
* Type of protection "e": Increased safety
* For zones 1 and 2.
* Supply of smaller air volumes only at medium resistances.
* Housing and impeller are made from high quality synthetic material, antistatic
* Semi-centrifugal impeller, favourable flow technology.
* Inflow direction equals outflow direction. Thus resulting in simple installation.
* Can be fitted in any position.

Air flow direction
* Airstream and rotational directions are indicated by arrows marked on the fan housing

Motor
* Robust motor with ball bearings, maintenance-free.
* Capacitor motors with operating capacitor ready for use in terminal box.

Mounting instructions
* Inlet and outlet side connection couplings for direct installation in ventilation ducts.
* Reducers for connecting to different duct diameters (intake or exhaust sockets); see Accessories.
* Use ELM-Ex flexible cuffs to prevent transfer of vibrations onto the duct system.
* ERM 22 E Ex e: 2 reducers to DN 200 included in scope of delivery.

Electrical connection
* Terminal box fitted to fan housing, explosion proof.

Required safety technology
* MVEx motor safety switch to monitor the maximum motor current.
* Accessories needed for ERM...E Ex e.
* Type-examination tested according to Directive 94/9 EC (ATEX).
* Installation exclusively in non-explosive areas.

Safety instructions
* No speed control allowed.
* The fan may only be operated using the rated voltage shown on the rating plate.
* The fan may be operated only if the protection against accidental contact with the impeller is guaranteed to be in accordance with DIN EN 294 for fans with free inlet and outlet. To do this, fit an SGR-Ex protective grille.
* Ensure that foreign bodies cannot fall into or be sucked into the fan.

PDF Files


ERM-18 Datasheet

1 x Step switch S-5EC, 0-10V1 x filter pack (set of 2) pt no. 4438891 x 150mm - 200mm Round Reducer1 x 110 x 54mm Flat Channel Clip (Pack Of 5)1 x 110 x 54mm Round to Rectangular Adaptor - Long1 x Rectangular Airbrick Adaptor1 x 1mtr Round Ducting - 150mm1 x Belt Drive Cased Axial Fan - 560mm - L version1 x 400mm 304 stainless steel 90 Bend1 x ZAC- 560 -4-11 x Stainless Steel Duct Suspension Rings - SUR2001 x Stainless Steel Duct Suspension Rings - SUR1501 x 500mm Stainless Steel Spiral Ducting - 1 Meter1 x MEV300/160 Wireless Boost Switch - SWHWMEV1 x HRU Controller1 x Soler & Palau TCBB/4-560/L - IP651 x AC03TO-ADS-VFS-EN-9A (Three Phase)1 x HR-500 DP Heat Exchange Unit1 x ACO3/BD Changover Panel (Three Phase)1 x REV-3POL ATEX 11kW-25A ON/OFF1 x MV-B Dual Switch for use with Helios HQW plate fans,1 x Vent Axia Trickle & Boost Switch1 x Manual Overide Switch - MOS1 x Remote Indicator RED/GREEN - AM121 x MVEx 1,0 Atex Motor Protection Switch1 x Villiavent VTC low Spare Filter Set1 x M5/G4 filter kit for IDEO HR unit1 x Villiavent VSR 300 Spare Motor1 x AKOR Spare Filter1 x Spare filter Set for Energi Sava 300 & 400 HR unit1 x Spare filter pack for Energi Sava 210 HR unit1 x *VORT HRW 30 MONO Evo HCS - Single Room Heat Recovery Unit,1 x F7/G4 filter kit for IDEO HR unit1 x *VORT HRW 40 MONO Evo HCS WIFI - Single Room Heat Recovery Unit,1 x Spare filter for Energi Sava 380 HR unit1 x 110 x 54mm Short Rectangular to Round Adaptor Female1 x 110 x 54mm Elbow Bend Female1 x Male Ducting Connector - 250mm1 x 110 x 54mm Horizontal 45 Degree Bend1 x 110 x 54mm Rectangular Wall Plate1 x 110 x 54mm Vertical 90 Degree Bend1 x Impeller Side Guard - 450mm1 x Impeller Side Guard - 250mm1 x 110 x 54mm Equal Horizontal T-Piece1 x 110 x 54mm Low Profile Plastic Ducting - 1 Meter1 x 110 x 54mm Vertical 45 Degree Bend1 x 110 x 54mm Low Profile Plastic Ducting - 2 Meter1 x Elta EC Electronic Controller1 x Vent Axia KAF Kitchen Extract Fan - 560mm - 2 Pole - Three Phase1 x Jetflow-HIT Metal inline - 150mm1 x Impeller Side Guard - 560mm1 x 500mm Shoe Saddle - 300mm Spigot - 304 Stainless1 x Vent Axia KAF Kitchen Extract Fan - 560mm - 2 Pole - Single Phase1 x 80mm stainless steel 90 Bend1 x Elta SLC500/4B-1AC - IP551 x Elta Variable Speed Drive IP66 - 2.2KW1 x KRJ - 160 Inlet Guard for CBB/CBT fans1 x Acopel F400-560/1601 x Spiral Ducting 1 meter - 80mm1 x CBT-100N Centrifugal ATEX II 2G Exe II T3
Reviews
Circular Inline Silencers - 0.6M long - SLU-600
Circular Inline Silencers - 0.6M long - SLU-600
£ 50.56

I have a loft mount extractor fan which was very noisy. I ...