• Model:DVG-V560D4I

DVG-V 560D4/F400 IE2

£ 1,954.68 (excl. VAT)

£ 2,345.62 (inc. VAT)

DVG-V 560D4/F400 IE2Smoke Extract Roof Fan
The DVG smoke extract fans are used in case of fire to extract smoke gases from rooms, and also during normal working conditions for standard ventilation.

Smoke-free escape ways increase the chances to rescue people in case of fire.
The casing is manufactured from seawater resistant aluminium. The base frame consists of galvanised steel. The impeller with backward-curved blades is manufactured from galvanised steel. Motor outside air stream is cooled with fresh air.

• Smoke and heat extract unit + normal ventilation
• Up to 400°C / 120 min (F400/120, F400/90, F300, F200)
• Normal ventilation up to 120°C continuous operation
• Vertical exhaust
• Service switch serial
• Suitable for coastal applications
• Wide range of accessories
• Tested acc. to EN 12101-3 at LGAI, Barcelona
• CE-certified acc. to EN 12101-3, 2002-06 at TÜV Süd
The DVG smoke extract fans are used in case of fire to extract smoke gases from rooms, and also during normal working conditions for standard ventilation.

Smoke-free escape ways increase the chances to rescue people in case of a fire. For installation only on top of heated buildings.

The casing is manufactured from seawater resistant aluminium. The base frame consists of galvanised steel. The impeller with backward-curved blades is manufactured from galvanised steel.

Motor outside air stream is cooled with fresh air. Thermal motor protection on request (PTC or thermal contact). For frequency controlled units PTC must be ordered. For two speed fans (up to 4 kW) two speed switch is available as accessories (in this case thermal contact must be ordered; not suitable for PTC or without thermal contact). In case of fire eventual two speed switch, frequency inverter and all protective devices must be bridged to guarantee functional capability (connection direct to mains). At frequency controlled units additional EMC protection could be needed (on request).

Note (for EU market only): not affected by efficiency provisions of Commision Regulation (EU) No 327/2011 - exception 3 (c) (i) (a)
1 x Helios HRFD 355/2 TK1 x BIF 63JML 100L 3PH/4P 200DEG IE3 - 630mm Bifurcated Fan - JN3050031 x Helios TSD 3.0 Transformer Speed Control (400v)1 x Frequency converter RUCK - FU 075 201 x FU 075 04 Frequency Inverter (IP20)1 x ELTA - Three Phase Transformer 10amps1 x Remote Timer Control - 13512 x Push Timer Switch - ZA41 x Helios ZNE Electronic Fan Overrun Timer3 x Multi Input Run On Timer - 0 - 20min - CFCU1 x Time Delay Unit - DT20B1 x 7 Day Programmable TIMECLOCK1 x Elta Variable Speed Drive IP66 - 4.0KW1 x Helios - FIUK-11KW 24.0A - FREQUENCY INVERTER1 x FU 22 04 Frequency Inverter1 x Helios TSW 7.5 Amp Transformer speed controller2 x Vent Axia ACM 100 T (Timer Model) inline mixed flow duct fan1 x Vent Axia ACM 150 T (Timer Model) inline mixed flow duct fan1 x S&P MULTI-REG EC FAN CONTROLLER / INTERFACE2 x Helios TSW 3 Amp Transformer speed controller1 x RDS 11 Helios Transformer Controller With Motor Protection1 x Remote controller FLEX - for VEKO INT1 x HCFC 1.7 - Reversible Speed Controller for HCF sweep fans2 x Vent Axia ACM 150 inline mixed flow duct fan2 x Vent Axia ACM 125 T (Timer Model) inline mixed flow duct fan1 x RTRD - Three Phase Speed Controller - 2 Amp1 x Systemair Save Connect 2.0 Internet Module1 x Helios TSW MCB Amp Transformer speed controller1 x Helios TSW 10 Amp Transformer speed controller1 x Helios TSW 1.5 Amp Transformer speed controller1 x MV-B Dual Switch for use with Helios HQW plate fans,1 x Helios TSW 0.3Amp Compact Transformer speed controller1 x CS2 Current Switch1 x Vent Axia ACM 125 inline mixed flow duct fan2 x MWS 3 – Transformer Controller With Motor Protection2 x Isolator Switch - ISOSW1 x CMT-2 200/80 1.1KW - Single inlet centrifugal fan direct driven1 x Envirovent Silent MV160/100T Mixvent - Timer Model - 100mm - (5 year warranty)1 x Single phase speed controller by auto-transformer - RMB 3.5 Amp1 x Elta 6 Amp Electronic single phase speed controller with TK1 x Vent Axia ACM 100 inline mixed flow duct fan1 x KMBI 180 Connector rectangular/circular to install on the discharge of CMT1 x Elta 3 Amp Electronic single phase speed controller with TK1 x Helios HQW-200/2 - IP551 x BEAS-control module1 x RDS 7 Helios Transformer Controller With Motor Protection1 x KMBI 225 Connector rectangular/circular to install on the discharge of CMT1 x Single phase speed controller by auto-transformer - RMB 10.0 Amp1 x FAST-TRACK RANGE 90mm - Adaptor For Distribution Box
Reviews
DAOSL Back Draft Damper
DAOSL Back Draft Damper
£ 11.49

Look good, works well, except the shaft of the lanellae cuts...