• Model:DVG-V560D4I

DVG-V 560D4/F400 IE2

£ 1,861.60 (excl. VAT)

£ 2,233.92 (inc. VAT)

DVG-V 560D4/F400 IE2Smoke Extract Roof Fan
The DVG smoke extract fans are used in case of fire to extract smoke gases from rooms, and also during normal working conditions for standard ventilation.

Smoke-free escape ways increase the chances to rescue people in case of fire.
The casing is manufactured from seawater resistant aluminium. The base frame consists of galvanised steel. The impeller with backward-curved blades is manufactured from galvanised steel. Motor outside air stream is cooled with fresh air.

• Smoke and heat extract unit + normal ventilation
• Up to 400°C / 120 min (F400/120, F400/90, F300, F200)
• Normal ventilation up to 120°C continuous operation
• Vertical exhaust
• Service switch serial
• Suitable for coastal applications
• Wide range of accessories
• Tested acc. to EN 12101-3 at LGAI, Barcelona
• CE-certified acc. to EN 12101-3, 2002-06 at TÃœV Süd
The DVG smoke extract fans are used in case of fire to extract smoke gases from rooms, and also during normal working conditions for standard ventilation.

Smoke-free escape ways increase the chances to rescue people in case of a fire. For installation only on top of heated buildings.

The casing is manufactured from seawater resistant aluminium. The base frame consists of galvanised steel. The impeller with backward-curved blades is manufactured from galvanised steel.

Motor outside air stream is cooled with fresh air. Thermal motor protection on request (PTC or thermal contact). For frequency controlled units PTC must be ordered. For two speed fans (up to 4 kW) two speed switch is available as accessories (in this case thermal contact must be ordered; not suitable for PTC or without thermal contact). In case of fire eventual two speed switch, frequency inverter and all protective devices must be bridged to guarantee functional capability (connection direct to mains). At frequency controlled units additional EMC protection could be needed (on request).

Note (for EU market only): not affected by efficiency provisions of Commision Regulation (EU) No 327/2011 - exception 3 (c) (i) (a)
1 x Acoustic Commercial Kitchen Inline Exhaust Fan - MPS (Three Phase) - 315mm1 x Inline Hepa filter with housing & pre-filters2 x Ducted Outlet Option for H14 - HAP5001 x Contra Rotating TCBBx2-630 Cased Axial - Single Phase - IP65 - Soler & Palau1 x CBM-10/10 515 6P RE VR IP55 (230V50)F V51 x CBM 10/10 - 750watt 4P RE VR (3 Phase)1 x CBA-100 Inlet Flange for CBT-1001 x CHVB/4-3000/315 0,27KW 230V50 VE1 x AxZent 400 D2 High Temp Kitchen exhaust Fan1 x Ducting 90 Degree Bend - 400mm1 x CBM Low Pressure Centrifugal Fan - CBM 9/9 6 Pole 300watt VR RE1 x DDMP12-12 1F 1800W M6A4 DA81 x Elta SLC315-1EC -IE5 Motor- IP551 x Duct Suspension Rings - 160mm1 x Acoustic Commercial Kitchen Inline Exhaust Fan - MPS (Three Phase) - 250mm1 x DHS 500DV roof fan1 x CBM Low Pressure Centrifugal Fan - CBM 9/9 4 Pole 550watt VR RE1 x TFSR 125 M Black Centrifugal Roof Fan1 x CCpro 40 (1CC9402) Long Casing Extension1 x Spigot plate - 400mm1 x Axial Roof mounted Extract/Supply Fan- -HCTT/4-1000-A 5.5kw1 x HRB/4-500-35-BPNC1 x TFSR 125 M Red Centrifugal Roof Fan1 x TFSR 125 M Grey Centrifugal Roof Fan1 x Elta EC Electronic Controller1 x DHS 225EZ roof fan1 x Ducting 90 Degree Bend - 160mm1 x Biflow SB315-CON2-3 - High Temperature Bifurcated Fan1 x Clearflow CFHT Kitchen/High Temp Roof Fan - CFHT400/4-3AC1 x JMS-630 Mounting frame1 x Roof Axial Fan and Cowl - Three Phase -315mm1 x JMS-5601 x Ducting 30 Degree Bend - 450mm1 x TFSR 315 Sileo Red Centrifugal Roof Fan1 x TFSR 200 M Black Centrifugal Roof Fan1 x CCZ-404-T (three Phase)1 x AL 500 D2 01 AXIALINE - High Performance Long Cased Axial Fan1 x HRT/4-500/35-BPN1 x KBA- Inlet Mounting 2801 x HCFT/4-5001 x JBR N - 435 Flange to suit CRHB roof fans1 x Soler & Palau - HCBT/4-355/H - IP651 x Soaker Sheet to suit RA10001 x Elta Cased Axial Flange - 250mm1 x USD-12000 Rect to Circ coupling Flange For KABB/T kitchen fans1 x Soaker Sheet to suit RA8001 x DDMP 07-07 1F 1100W M6AO DA51 x Soler & Palau - HXTR/4-450/H - IP541 x Roof Axial Fan and Cowl - Three Phase -630mm1 x CBA-130 Inlet Flange for CBT-1302 x HRB/6-500-25-APN1 x Ducting Y Piece - 100mm1 x Soler & Palau - HCBT/4-710/H - IP651 x Elta SPA500/6-1AC - IP541 x Roof Axial Fan and Cowl - Three Phase -500mm1 x HRT/4-500/25-BPN C1 x KBD- outlet mounting flange for CRMT 2801 x Female Ducting Connector - 315mm1 x Spiral Ducting 3 Meters - 355mm1 x Soler & Palau - HCBT/6-500/H - IP651 x USD-3000 Rect to Circ coupling Flange For KABB/T kitchen fans1 x HRB/4-500-25-BPN1 x CBS-80 Outlet Flange for CBT-801 x Impeller Side Guard - 560mm
Reviews
Circular Inline Silencers - 0.6M long - SLU-600
Circular Inline Silencers - 0.6M long - SLU-600
£ 50.56

I have a loft mount extractor fan which was very noisy. I ...