• Model:DVG-V560D4I

DVG-V 560D4/F400 IE2

£ 1,861.60 (excl. VAT)

£ 2,233.92 (inc. VAT)

DVG-V 560D4/F400 IE2Smoke Extract Roof Fan
The DVG smoke extract fans are used in case of fire to extract smoke gases from rooms, and also during normal working conditions for standard ventilation.

Smoke-free escape ways increase the chances to rescue people in case of fire.
The casing is manufactured from seawater resistant aluminium. The base frame consists of galvanised steel. The impeller with backward-curved blades is manufactured from galvanised steel. Motor outside air stream is cooled with fresh air.

• Smoke and heat extract unit + normal ventilation
• Up to 400°C / 120 min (F400/120, F400/90, F300, F200)
• Normal ventilation up to 120°C continuous operation
• Vertical exhaust
• Service switch serial
• Suitable for coastal applications
• Wide range of accessories
• Tested acc. to EN 12101-3 at LGAI, Barcelona
• CE-certified acc. to EN 12101-3, 2002-06 at TÃœV Süd
The DVG smoke extract fans are used in case of fire to extract smoke gases from rooms, and also during normal working conditions for standard ventilation.

Smoke-free escape ways increase the chances to rescue people in case of a fire. For installation only on top of heated buildings.

The casing is manufactured from seawater resistant aluminium. The base frame consists of galvanised steel. The impeller with backward-curved blades is manufactured from galvanised steel.

Motor outside air stream is cooled with fresh air. Thermal motor protection on request (PTC or thermal contact). For frequency controlled units PTC must be ordered. For two speed fans (up to 4 kW) two speed switch is available as accessories (in this case thermal contact must be ordered; not suitable for PTC or without thermal contact). In case of fire eventual two speed switch, frequency inverter and all protective devices must be bridged to guarantee functional capability (connection direct to mains). At frequency controlled units additional EMC protection could be needed (on request).

Note (for EU market only): not affected by efficiency provisions of Commision Regulation (EU) No 327/2011 - exception 3 (c) (i) (a)
1 x MEV 160 & 300 FT (FastTrack) Additional Spigots1 x JBS-1250 Flat Roof Upstand for HCTT/4-1000/B1 x Axial Roof mounted Extract/Supply Fan- -HCTT/4-900-B 5.5kw1 x DEF-800AN1 x Soler & Palau - HCBT/4-800/H-B FLOW ( Supply Air Fan) - IP551 x FAST-TRACK RANGE 90mm - Semi-Rigid Duct 50M1 x KABT High Temp Acoustic Kitchen Fan & Inverter Kit - KABT/4-12000/560 ND - Pack 51 x Elta Skyflow SSRL630-1EC1 x Kitchen Extract Grille with Grease Filter - 600 x 100 - NO GRILL BOX1 x Soaker Sheet to suit RA500/5601 x Kitchen Extract Grille with Grease Filter - 450 x 150 - NO GRILL BOX1 x Soaker Sheet to suit RA315/3001 x Female Ducting Connector - 100mm1 x RTRD - Three Phase Speed Controller - 2 Amp1 x Male Ducting Connector - 125mm1 x Soaker Sheet to suit RA630/7101 x TFSR 125 M Grey Centrifugal Roof Fan1 x FK 125 Fast Clamp1 x Kitchen Extract Grille with Grease Filter - 280x185 - CEF NO GRILL BOX1 x Envirovent Silent MV160/100T Mixvent - Timer Model - 100mm - (5 year warranty)1 x Duct Fast Clamps - 125mm1 x Ducting 45 Degree Bend - 125mm1 x Ducting Y Piece - 125mm1 x Elta SPA450/4-1AC - IP541 x TFSR 200 M Grey Centrifugal Roof Fan1 x TFSR 315 Sileo Red Centrifugal Roof Fan1 x Impeller Side Guard - 560mm1 x TPSB/2-225/088 Centrifugal Roof Mounted Fan1 x Ducting T Piece Equal - 125mm1 x Commercial Thermostat - TH161 x Clearflow CFHT Kitchen/High Temp Roof Fan - CFHT630/4-3AC1 x Soaker Sheet to suit RA10001 x DVG-V 560D4/F400 IE21 x HIMF - Mixed Flow Fan 125mm Inline Fan1 x DHS 225EZ roof fan
Air Quality Sensor - AQS
Air Quality Sensor - AQS
£ 98.29 now £ 65.00
Reviews
Transformer (silent) speed controller - RE 1.5 Amp
Transformer (silent) speed controller - RE 1.5 Amp
£ 125.99

Unbelievable! With TDmixvent500: noise reduction minimum 50%...