• Model:DVG-V560D4I

DVG-V 560D4/F400 IE2

£ 1,954.68 (excl. VAT)

£ 2,345.62 (inc. VAT)

DVG-V 560D4/F400 IE2Smoke Extract Roof Fan
The DVG smoke extract fans are used in case of fire to extract smoke gases from rooms, and also during normal working conditions for standard ventilation.

Smoke-free escape ways increase the chances to rescue people in case of fire.
The casing is manufactured from seawater resistant aluminium. The base frame consists of galvanised steel. The impeller with backward-curved blades is manufactured from galvanised steel. Motor outside air stream is cooled with fresh air.

• Smoke and heat extract unit + normal ventilation
• Up to 400°C / 120 min (F400/120, F400/90, F300, F200)
• Normal ventilation up to 120°C continuous operation
• Vertical exhaust
• Service switch serial
• Suitable for coastal applications
• Wide range of accessories
• Tested acc. to EN 12101-3 at LGAI, Barcelona
• CE-certified acc. to EN 12101-3, 2002-06 at TÜV Süd
The DVG smoke extract fans are used in case of fire to extract smoke gases from rooms, and also during normal working conditions for standard ventilation.

Smoke-free escape ways increase the chances to rescue people in case of a fire. For installation only on top of heated buildings.

The casing is manufactured from seawater resistant aluminium. The base frame consists of galvanised steel. The impeller with backward-curved blades is manufactured from galvanised steel.

Motor outside air stream is cooled with fresh air. Thermal motor protection on request (PTC or thermal contact). For frequency controlled units PTC must be ordered. For two speed fans (up to 4 kW) two speed switch is available as accessories (in this case thermal contact must be ordered; not suitable for PTC or without thermal contact). In case of fire eventual two speed switch, frequency inverter and all protective devices must be bridged to guarantee functional capability (connection direct to mains). At frequency controlled units additional EMC protection could be needed (on request).

Note (for EU market only): not affected by efficiency provisions of Commision Regulation (EU) No 327/2011 - exception 3 (c) (i) (a)
1 x Etamaster EM 250 EC 01 inline mix-vent fan1 x CBMT/Q 250-54 1 HEATER KIT1 x Etamaster EM 250 EC 02 (high Power) inline mix-vent fan1 x Round ceiling diffuser 300mm1 x Round ceiling diffuser 250mm1 x CMT-2 200/80 1.1KW - Single inlet centrifugal fan direct driven1 x KMBI 180 Connector rectangular/circular to install on the discharge of CMT1 x Vent Axia ACM 150 T (Timer Model) inline mixed flow duct fan1 x Three Phase Transformer controllers - RMT 1.5 Amp1 x Vent Axia ACM 100 T (Timer Model) inline mixed flow duct fan1 x HCFC 1.7 - Reversible Speed Controller for HCF sweep fans1 x Helios TSW 0.3Amp Compact Transformer speed controller1 x Helios TSW 3 Amp Transformer speed controller1 x Vent Axia ACM 100 inline mixed flow duct fan2 x Envirovent 4 Way Remote Control Switch - SWHBKRF-41 x Vent Axia ACM 150 inline mixed flow duct fan1 x Helios TSW 1.5 Amp Transformer speed controller2 x Vent Axia ACM 125 T (Timer Model) inline mixed flow duct fan1 x CS2 Current Switch2 x DEF-140T Inlet Guard for the CBT-100N1 x Isolator Switch - ISOSW1 x MWS 3 – Transformer Controller With Motor Protection1 x Single phase speed controller by auto-transformer - RMB 3.5 Amp1 x Vent Axia ACM 125 inline mixed flow duct fan2 x Envirovent Silent MV160/100T Mixvent - Timer Model - 100mm - (5 year warranty)1 x Multiflow SMB550/4-1AC2 x Elta 6 Amp Electronic single phase speed controller with TK1 x Multi Input Run On Timer - 0 - 20min - CFCU1 x Push Timer Switch - ZA41 x MV-B Dual Switch for use with Helios HQW plate fans,1 x BEAS-control module1 x Helios HQW-200/2 - IP551 x Systemair Save Connect 2.0 Internet Module
BD9/9 centrifugal M4 0.35Kw
BD9/9 centrifugal M4 0.35Kw
£ 399.00 now £ 350.00
Reviews
Airvent Ceiling Sweep Fan - 36 inch - 444122
Airvent Ceiling Sweep Fan - 36 inch - 444122
£ 59.84

Fitted 2 Of These Excellent Fans in a Community Club to shif...