• Model:DVG-V560D4I

DVG-V 560D4/F400 IE2

£ 1,861.60 (excl. VAT)

£ 2,233.92 (inc. VAT)

DVG-V 560D4/F400 IE2Smoke Extract Roof Fan
The DVG smoke extract fans are used in case of fire to extract smoke gases from rooms, and also during normal working conditions for standard ventilation.

Smoke-free escape ways increase the chances to rescue people in case of fire.
The casing is manufactured from seawater resistant aluminium. The base frame consists of galvanised steel. The impeller with backward-curved blades is manufactured from galvanised steel. Motor outside air stream is cooled with fresh air.

• Smoke and heat extract unit + normal ventilation
• Up to 400°C / 120 min (F400/120, F400/90, F300, F200)
• Normal ventilation up to 120°C continuous operation
• Vertical exhaust
• Service switch serial
• Suitable for coastal applications
• Wide range of accessories
• Tested acc. to EN 12101-3 at LGAI, Barcelona
• CE-certified acc. to EN 12101-3, 2002-06 at TÃœV Süd
The DVG smoke extract fans are used in case of fire to extract smoke gases from rooms, and also during normal working conditions for standard ventilation.

Smoke-free escape ways increase the chances to rescue people in case of a fire. For installation only on top of heated buildings.

The casing is manufactured from seawater resistant aluminium. The base frame consists of galvanised steel. The impeller with backward-curved blades is manufactured from galvanised steel.

Motor outside air stream is cooled with fresh air. Thermal motor protection on request (PTC or thermal contact). For frequency controlled units PTC must be ordered. For two speed fans (up to 4 kW) two speed switch is available as accessories (in this case thermal contact must be ordered; not suitable for PTC or without thermal contact). In case of fire eventual two speed switch, frequency inverter and all protective devices must be bridged to guarantee functional capability (connection direct to mains). At frequency controlled units additional EMC protection could be needed (on request).

Note (for EU market only): not affected by efficiency provisions of Commision Regulation (EU) No 327/2011 - exception 3 (c) (i) (a)
1 x Anti Vibration Duct Suspension Rings - 100mm1 x CBM Low Pressure Centrifugal Fan - CBM 9/9 6 Pole 300watt VR RE1 x Duct Fast Clamps - 100mm1 x Ducting 15 Degree Bend - 150mm1 x Elta - SMT 125 Mixvent Inline Fan - Clearance Stock Line1 x Slim Qube SSQU23/4-3HT1 x International Shipping Surcharge1 x Activated Carbon Discarb Cell - Grade 50 - EXTRA DUTY - 445H x 445W x 595Dmm ACTUAL1 x Anti Vibration Duct Suspension Rings - 150mm1 x Revolution SLCX ATEX Long Cased Axial Flow Fan SLCX400/2-3 Three Phase1 x TFSR 315 Sileo Grey Centrifugal Roof Fan1 x Skyflow SSR Horizontal Roof Cowl SSR31/35B1 x Soler & Palau - Contra Rotating TCBTx2-500 - IP651 x CRVT/4-560 N Roof mounted Fan - vertical discharge1 x FlameProof Plate Axial Fan - Single Phase - 9 inches - Eexd IIC T4 -2pole1 x TFSR 125 M Red Centrifugal Roof Fan2 x STF1 Oscillating Tower Fan2 x Slim Qube SSQU4/6-3HT2 x Spiral end cap - 150mm1 x Clearflow CFHT Kitchen/High Temp Roof Fan - CFHT630/4-3AC1 x Ancillary Sealing Band - 150mm1 x Ducting 30 Degree Bend - 150mm1 x Ducting 90 Degree Bend - 100mm1 x Soler & Palau - HCBT/4-800/H-B FLOW ( Supply Air Fan) - IP551 x TFSR 200 M Grey Centrifugal Roof Fan1 x CRHT/4-315 N Roof mounted Fan - Horizontal discharge1 x KBR 355D2 IE2 Thermo fan1 x G2 duct Mounted Panel Filter - 594 x 594 x 47mm1 x Clearflow CFHT Kitchen/High Temp Roof Fan - CFHT400/4-3AC1 x CRHB/6- 630mm Roof mounted Fan - Horizontal discharge1 x Elta Wall Cowl SWC35/401 x DVV 800D4-XL/F400 smoke extr1 x Ziehl-Abegg FN050-6EQ.4F.V7P11 x Axial Roof mounted Extract/Supply Fan- -HCTT/4-900-B 5.5kw2 x Airvent Ceiling Sweep Fan - 36 inch - 4441221 x Ducting 45 Degree Bend - 150mm1 x Nicotra Direct Delivery Surcharge1 x FlameProof Plate Axial Fan - Three Phase - 10.5 inches - Eexd IIC T4 -2pole1 x KMBI 225 Connector rectangular/circular to install on the discharge of CMT1 x Vent Axia KAF Kitchen Extract Fan - 630mm - 2 Pole - Three Phase1 x Slim Qube SSQU22/4-3HT1 x MUB/T 062 630 D4 Centrifugal box fan, 120°C Continuous, Insulated1 x Elta SLC630/4-1AC - IP551 x JMS-5601 x Hydor Typhoon Circulation Fans - HVFB - 300mm1 x AW 355 D4-2-EX Explosion Proof Axial Fan - ATEX1 x Spiral Ducting 1 meter - 250mm1 x Roof Axial Fan and Cowl - Three Phase -315mm1 x TFSR 200 M Black Centrifugal Roof Fan1 x Elta Raptor SFB ATEX Plate Mounted Axial Fan- 350mm1 x Biflow SB (CYL) Bifurcated Cylindrical Axial Flow Fan - 400mm1 x HCF - Ceiling Fan 1200mm (48 inch)1 x Purlin Box 630/710 for RAW Cowls1 x Airvent Ceiling Sweep Fan - 48 inch - 4441231 x Three Phase ATEX Compact axial fan - 800mm - compactATEX81 x TFSR 125 M Black Centrifugal Roof Fan1 x Three Phase ATEX Compact axial fan - 450mm - compactATEX41 x Roof Axial Fan and Cowl - Three Phase -250mm1 x Biflow SB250-CON4-1 - High Temperature Bifurcated Fan1 x Slim Qube SSQU24/4-3BHT1 x Airvent Ceiling Sweep Fan - 56 inch - 4441241 x Elta SLC560/4B-1AC - IP551 x Anti Vibration Mounts - Large - Pack of 4 - AVM11 x DVG-V 560D4-8/F4001 x Flanged Spigot - 150mm
Air Quality Sensor - AQS
Air Quality Sensor - AQS
£ 98.29 now £ 65.00
Reviews
Circular Inline Silencers - 0.6M long - SLU-600
Circular Inline Silencers - 0.6M long - SLU-600
£ 50.56

I have a loft mount extractor fan which was very noisy. I ...