• Model:DVG-V560D4I

DVG-V 560D4/F400 IE2

£ 1,861.60 (excl. VAT)

£ 2,233.92 (inc. VAT)

DVG-V 560D4/F400 IE2Smoke Extract Roof Fan
The DVG smoke extract fans are used in case of fire to extract smoke gases from rooms, and also during normal working conditions for standard ventilation.

Smoke-free escape ways increase the chances to rescue people in case of fire.
The casing is manufactured from seawater resistant aluminium. The base frame consists of galvanised steel. The impeller with backward-curved blades is manufactured from galvanised steel. Motor outside air stream is cooled with fresh air.

• Smoke and heat extract unit + normal ventilation
• Up to 400°C / 120 min (F400/120, F400/90, F300, F200)
• Normal ventilation up to 120°C continuous operation
• Vertical exhaust
• Service switch serial
• Suitable for coastal applications
• Wide range of accessories
• Tested acc. to EN 12101-3 at LGAI, Barcelona
• CE-certified acc. to EN 12101-3, 2002-06 at TÃœV Süd
The DVG smoke extract fans are used in case of fire to extract smoke gases from rooms, and also during normal working conditions for standard ventilation.

Smoke-free escape ways increase the chances to rescue people in case of a fire. For installation only on top of heated buildings.

The casing is manufactured from seawater resistant aluminium. The base frame consists of galvanised steel. The impeller with backward-curved blades is manufactured from galvanised steel.

Motor outside air stream is cooled with fresh air. Thermal motor protection on request (PTC or thermal contact). For frequency controlled units PTC must be ordered. For two speed fans (up to 4 kW) two speed switch is available as accessories (in this case thermal contact must be ordered; not suitable for PTC or without thermal contact). In case of fire eventual two speed switch, frequency inverter and all protective devices must be bridged to guarantee functional capability (connection direct to mains). At frequency controlled units additional EMC protection could be needed (on request).

Note (for EU market only): not affected by efficiency provisions of Commision Regulation (EU) No 327/2011 - exception 3 (c) (i) (a)
1 x STF1 Oscillating Tower Fan1 x EC-Vent control board1 x Airvent Ceiling Sweep Fan - 36 inch - 4441221 x Ducting 90 Degree Bend - 400mm1 x Female Ducting Connector - 400mm1 x Spiral Ducting 3 Meters - 315mm1 x RUCK MTP 30, Stepped Speed control1 x Mounting Feet (Pair) for SLC-710-060B-07101 x UB47- Universal Insulated Terminal1 x Ducting 90 Degree Bend - 250mm1 x TILEVENT Universal Roof Outlet - Grey1 x Skyflow SSR Horizontal Roof Cowl SSR31/35BS1 x Airvent ceiling fan controller1 x Desk fan 9 inch - SFG91 x ELTA - Single Phase Transformer 12amps1 x GORDON W 30/12″ ET Oscillating wall mounted fan with remote control1 x KVK Silent 355 Centrifugal circular duct fan1 x Wooden Sauna Fan Series - MM ST 1001 x HCFC 1.7 - Reversible Speed Controller for HCF sweep fans1 x Hydor Typhoon Circulation Fans - HVFB - 300mm2 x Elta SCP400/4-1AC - IP551 x HCF - Ceiling Fan 900mm (36 inch)1 x Airvent Ceiling Sweep Fan - 48 inch - 4441231 x Spiral Ducting 3 Meters - 400mm1 x Male Ducting Connector - 315mm1 x GB-WK 250 Wall Bracket For Giga Box Fans - 250mm - 355mm1 x MFA-AR/AXC 315 mounting foot1 x Mounting Feet (Pair) for SLC-450-060B-04501 x GX6 Wall Kit1 x MTG FEET & ANTI VIB. MOUNTS (SET OF 4) for MFQ560/4/31 x Mounting Feet (Pair) for SLC-500-060B-05001 x Mounting Feet (Pair) for SLC-900-060B-09001 x Mounting Feet (pair) for SB-CON 4001 x HCFT/4-450mm plastic impeller plate fan1 x Mounting Feet 160-180 (pair) for ADH E0-01601 x Spiral Duct Grille Termination - 125mm1 x Mounting Feet (pair) for SB-CON 2501 x Mounting Feet (pair) for SB-CON 3151 x Ducting 15 Degree Bend - 560mm1 x Blast Gate (Manual) 125mm1 x DVV 800D4-XL/F400 smoke extr1 x DA9/9 Feet1 x TFSR 315 Sileo Black Centrifugal Roof Fan1 x Ductwrap Insulation DW501 x Ducting Y Piece - 125mm1 x Spiral Ducting 3 Meters - 125mm1 x CRVT/6-630 Roof mounted Fan - vertical discharge1 x Duct Humidistat - HS4_hdt1 x Spiral Ducting 3 Meters - 355mm1 x Ducting 45 Degree Bend - 125mm1 x Ducting T Piece Equal - 125mm1 x Clearflow CF Roof Mounted Vertical Discharge Centrifugal Fan - CF450/4-3AC - Three Phase1 x Clearflow CFHT Kitchen/High Temp Roof Fan - CFHT400/4-3AC1 x Anti Vibration Duct Suspension Rings - 125mm1 x TFSR 125 M Grey Centrifugal Roof Fan1 x CRVT/4-560 N Roof mounted Fan - vertical discharge1 x Spiral end cap - 250mm1 x Ducting 90 Degree Bend - 125mm1 x Clearflow CF Roof Mounted Vertical Discharge Centrifugal Fan - CF400/4-3AC - Three Phase1 x 125mm Insulated Round T-Piece1 x Duct Tape - Silver - DTape
Reviews
Duct Mounted Inline Filter - EU4
Duct Mounted Inline Filter - EU4
£ 41.95

Well made and robust, but it was not use for my application ...