• Model:DVG-V560D4I

DVG-V 560D4/F400 IE2

£ 1,861.60 (excl. VAT)

£ 2,233.92 (inc. VAT)

DVG-V 560D4/F400 IE2Smoke Extract Roof Fan
The DVG smoke extract fans are used in case of fire to extract smoke gases from rooms, and also during normal working conditions for standard ventilation.

Smoke-free escape ways increase the chances to rescue people in case of fire.
The casing is manufactured from seawater resistant aluminium. The base frame consists of galvanised steel. The impeller with backward-curved blades is manufactured from galvanised steel. Motor outside air stream is cooled with fresh air.

• Smoke and heat extract unit + normal ventilation
• Up to 400°C / 120 min (F400/120, F400/90, F300, F200)
• Normal ventilation up to 120°C continuous operation
• Vertical exhaust
• Service switch serial
• Suitable for coastal applications
• Wide range of accessories
• Tested acc. to EN 12101-3 at LGAI, Barcelona
• CE-certified acc. to EN 12101-3, 2002-06 at TÃœV Süd
The DVG smoke extract fans are used in case of fire to extract smoke gases from rooms, and also during normal working conditions for standard ventilation.

Smoke-free escape ways increase the chances to rescue people in case of a fire. For installation only on top of heated buildings.

The casing is manufactured from seawater resistant aluminium. The base frame consists of galvanised steel. The impeller with backward-curved blades is manufactured from galvanised steel.

Motor outside air stream is cooled with fresh air. Thermal motor protection on request (PTC or thermal contact). For frequency controlled units PTC must be ordered. For two speed fans (up to 4 kW) two speed switch is available as accessories (in this case thermal contact must be ordered; not suitable for PTC or without thermal contact). In case of fire eventual two speed switch, frequency inverter and all protective devices must be bridged to guarantee functional capability (connection direct to mains). At frequency controlled units additional EMC protection could be needed (on request).

Note (for EU market only): not affected by efficiency provisions of Commision Regulation (EU) No 327/2011 - exception 3 (c) (i) (a)
1 x Binks Bullows - Spray Booth Filter1 x Male Ducting Connector - 180mm1 x 204x60mm Equal T Piece1 x S & P Aluminium Axial Fan Louvre Shutter - PER-CR- 5001 x Elta Cased Axial Flange - 560mm1 x 110 x 54mm Low Profile Plastic Ducting - 2 Meter1 x CTVB/4-315 Kitchen/High Temp Roof Fan1 x Spiral Ducting 3 Meters - 315mm1 x Spiral Ducting 3 Meters - 80mm1 x MPS 225 D2 F4 301 x Elta SCP500-1EC - IP551 x TFSR 200 M Grey Centrifugal Roof Fan1 x Egg Crate Grille with G2 Dust panel filter 1 inch- 300x3001 x Helios GigaBox 630mm GBD 630/4 T120 centrifugal1 x Soaker Sheet to suit RA315/3001 x 204x60mm Elbow Bend with 100mm Fixed Spigot1 x TFSR 200 M Black Centrifugal Roof Fan1 x TPSB/2-225/088 Centrifugal Roof Mounted Fan1 x Helios GigaBox 500mm GBW 500/4 T120 centrifugal1 x 125mm Round Connector1 x ILHT/4-500 CC - High Temp Rectangle Duct Fan1 x Biflow SB (CYL) Bifurcated Cylindrical Axial Flow Fan - 630mm1 x Helios GigaBox 450mm GBW 450/4 T120 centrifugal1 x HV Wall Mounted Belt Drive Fan 1500mm 220V to 240V / 50Hz 1.5kW - Single Phase1 x KBR 315D2 IE2 Thermo fan1 x 1mtr Round Ducting - 100mm1 x Speed Controller - REB2.5-N1 x ILHT/4-560 MV - High Temp Rectangle Duct Fan1 x TFSR 200 M Red Centrifugal Roof Fan1 x 204x60mm Elbow Bend with 125mm Fixed Spigot1 x Egg Crate Grille with Dust panel filter 1 inch- 300x3001 x ILHT/4-500 MV - High Temp Rectangle Duct Fan1 x Ancillary Pack for SB-CYL 630 model1 x Soler & Palau VFD-T inverter 9 amp IP541 x TPSB-250/084 ECOWATT Roof Mounted Fan1 x FAST-TRACK RANGE 75mm - Seal Ring (1 bag of 10)1 x Smoke Extract Axial Fan Series AXC 450 (B)1 x Soaker Sheet to suit RA8001 x Ducting T Piece Equal - 250mm1 x Small High Temp Gas Blower - FET 3001 x 204x60mm x 1000mm Long Hi-Flow Duct Silencer1 x Spiral Ducting 1 meter - 180mm1 x ERM180EXE Bracket1 x Etaline 150mm - EL 150L E2 011 x Etaline 355mm - E2-011 x 204 x 60mm Duct to Duct Connector for use with Insulated Thermal Ducting1 x Soler & Palau - HCBT/4-800/H-B FLOW ( Supply Air Fan) - IP551 x Anti Vibration Duct Suspension Rings - 315mm1 x Speed Controller - REB101 x Spigot plate - 100mm1 x DHS 500DV roof fan1 x Ducting 30 Degree Bend - 180mm1 x CTVB/4-200 Kitchen/High Temp Roof Fan1 x Clearflow CF Roof Mounted Vertical Discharge Centrifugal Fan - CF315/4-1AC - Single Phase1 x DHS 225EZ roof fan1 x DHS 400E4 roof fan1 x CRVT/6-630 Roof mounted Fan - vertical discharge1 x Biflow SB250-CON4-1 - High Temperature Bifurcated Fan1 x Ducting 45 Degree Bend - 315mm
Air Quality Sensor - AQS
Air Quality Sensor - AQS
£ 98.29 now £ 65.00
Reviews
DAOSL Back Draft Damper
DAOSL Back Draft Damper
£ 10.53

Look good, works well, except the shaft of the lanellae cuts...