• Model:GasInt-002

Gas Interlock system with Gas On Lamp

£ 184.74 (excl. VAT)

£ 221.69 (inc. VAT)

The GVI-002 is a gas interlock control system that can be used with either pressure switches or current sensors to monitor fans and enable the electrical supply to a gas valve actuator..

Control panel features
• Airflow off lamp
• Airflow on lamp
• Gas on lamp
• 10 second overrun timer to overcome loss of supply to gas valve actuator in case of backdrafts

The GVI-002 has connections for 2 current sensors. When fan current flow is proved the airflow on lamp will light and the electrical supply to the gas valve actuator will be enabled, the gas on lamp will light. When there is a loss of fan current the gas valve actuator will remain enabled for 10 seconds. This is to prevent loss of gas in the event of backdrafts. If a supply fan current sensor is fitted then both supply and extract fan current flow is to be proved before the airflow on lamp lights and the electrical supply to the gas valve actuator is enabled.

Control panel connections
• Electrical supply: 230v 1Ph 50Hz
• Remote emergency stop button
• Pressure switch/current sensor for supply fan • Pressure switch/current sensor for extract fan • Gas valve actuator: 230v 1Ph 50Hz motor open, spring return

Remote emergency stop button connections
The GVI-002 has connections to allow the fitting of a remote emergency stop button if required. Ask for details. When this is activated the electrical supply to the gas valve actuator will be disabled.

Be advised pressure switches are considered better than current switches for proving airflow.

Download specifications HERE

Available Options

1 x Speed Controller - REB51 x Frequency converter RUCK - FU 075 201 x Elta Variable Speed Drive IP66 - 4.0KW1 x FRQ5-10A Inverter Speed controller1 x Frequency converter RUCK - FU 075 211 x FU 22 04 Frequency Inverter1 x Balance S Diffuser - NO RING - 125mm1 x Circular Ceiling Diffuser - TST 2001 x Elta 6 Amp Electronic single phase speed controller with TK1 x ELTA - Single Phase Transformer 16amps1 x Balance S Diffuser - NO RING - 100mm1 x EFSC-3N- Single Phase Speed Control1 x Elta 3 Amp Electronic single phase speed controller with TK1 x Airvent ceiling fan controller1 x Elta 3 Amp Electronic single phase speed controller.1 x ELTA - Single Phase Transformer 8amps1 x Round ceiling diffuser 200mm1 x Round ceiling diffuser 300mm1 x ELTA - Single Phase Transformer 12amps1 x ELTA - Single Phase Transformer 4amps1 x AIRVENT speed control - AIR4019611 x Round ceiling diffuser 250mm1 x Round ceiling diffuser 350mm2 x EFSC-6N- Single Phase Speed Control1 x Elta 6 Amp Electronic single phase speed controller.1 x PCA Diffuser - PCA-2501 x CS2 Current Switch1 x Remote Timer Control - 13511 x Run On Timer - 5s - 4hrs - RT5A1 x Elta 10 Amp Electronic single phase speed controller.1 x NKS-D swirl diffuser v-300 x 300mm1 x PCA Diffuser - PCA-3151 x Electronic extractor fan speed controller - FSC 1.51 x JSR 200 Painted RAL50181 x Elta 2 Amp Electronic single phase speed controller.1 x Push Timer Switch - ZA41 x Helios ZNE Electronic Fan Overrun Timer2 x Multi Input Run On Timer - 0 - 20min - CFCU1 x Time Delay Unit - DT20B1 x CMT-2 200/80 1.1KW - Single inlet centrifugal fan direct driven1 x 7 Day Programmable TIMECLOCK1 x TTC-2000 Three phase electric heater controller1 x ACO8AC/EC AutoChangeover panel1 x ACOAS/ AC/EC Auto Changeover 8Amp1 x KMBI 180 Connector rectangular/circular to install on the discharge of CMT1 x Elta ACO Panel 149-ACO14E1 x EC-Vent control board1 x CONTROL ECOWATT - Basic
Reviews
DAOSL Back Draft Damper
DAOSL Back Draft Damper
£ 11.49

Look good, works well, except the shaft of the lanellae cuts...