• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,438.15 (excl. VAT)

£ 4,125.78 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x Bellimo TF24S Actuator 24V1 x FSD-TD 250mm Fire and Smoke Damper, Type C, EASY FIX AF, GALV Case, GALV Blades, PM230-TF (SC)1 x FSD-TD 350 x 350 Fire and Smoke Damper, S, EASY FIX AF, GALV Case, GALV Blades, PM230-TF (SC)1 x FSD-C Motorised Failsafe Single Blade Fire/Smoke Damper with Actuator - 180mm1 x FSD-TD 200mm Fire and Smoke Damper, Type C, EASY FIX AF, GALV Case, GALV Blades, PM230-TF (SC)1 x FSD-TD 150mm Fire and Smoke Damper, Type C, EASY FIX AF, GALV Case, GALV Blades, PM230-TF (SC)1 x FSD-TD 350mm Fire and Smoke Damper, Type C, EASY FIX AF, GALV Case, GALV Blades, PM230-TF (SC)1 x Systemair AW Sileo 710-DS1 x Additional shipping charge for offshore islands1 x 100mm Wall Duct - 350mm1 x Air Quality Sensor - AQS1 x European Pallet Delivery Surcharge1 x Carriage1 x Hydor Typhoon Circulation Fans - HVFB - 450mm1 x 100mm Round Connector1 x 125mm Round Connector1 x DS-2/2 2-Speed Switch IP54 (Single Phase)1 x 110 x 54mm Short Rectangular to Round Adaptor male1 x Elta Prema LCD Display1 x 125mm Thermal Duct to Fitting Connector - SST-125-DFCON1 x Flexible PVC Ducting - 204x601 x CBT-130N Centrifugal ATEX II 2G Exd IIB T41 x CBT-60N Centrifugal1 x Delivery Surcharge1 x 204x60mm x 1m Low Profile Plastic Ducting - 1 Meter1 x Manual Overide Switch - MOS1 x GB-WSD 400 Weather Protection hood for the Giga-Box Fans - 400mm1 x DKEX 355-6 Centrifugal High Performance ATEX Fan1 x 125mm Wall Duct - 350mm1 x MPC 450 E4 20 - High Temp Acoustic Box Fan1 x GB-WSD 450 Weather Protection hood for the Giga-Box Fans - 450mm1 x Pre 12:00 Delivery Surcharge1 x Genius Whole house unit -1 x 204x60mm Rectangular to 100mm Round Adaptor1 x BKF 800D6-XL/F400 IE3 - Centrifugal rectangular duct fan 400C/2h1 x Elta SPA710/6-3EC1 x CBT-100 N (230/400V50HZ) LG270-EXDIIBT4
Reviews
Transformer (silent) speed controller - RE 1.5 Amp
Transformer (silent) speed controller - RE 1.5 Amp
£ 125.99

Unbelievable! With TDmixvent500: noise reduction minimum 50%...