• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,438.15 (excl. VAT)

£ 4,125.78 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x HD Series Control Damper - 3000mm X 1500mm1 x Duct Fast Clamps - 100mm1 x Anti Vibration Duct Suspension Rings - 160mm1 x Access Door for Circular Duct - 250 x 150 - SIZE 311 x Access Door for Circular Duct - 250 x 150 - SIZE 251 x CBT-100N Centrifugal ATEX II 2G Exe II T31 x Spiral Ducting 1 meter - 100mm1 x Blast Gate (Manual) 180mm1 x IK - Inspection Door & Drain Plug for TLZ 450 R1 x Ducting 45 Degree Bend - 250mm1 x CVAT/4-4000/400 ND 0.37Kw (230/400V50HZ) EXDIIBHT4 - ATEX RATED CABINET FAN1 x HD Series Control Damper - 2000mm X 1000mm1 x ECS25/400 ECS25/400 SPRING A/V MOUNT1 x ACCESS DOOR FOR CIRCULAR DUCT 180 X 180 -- 100/1251 x Elta Box Fan AV Mounts - 063-SEL03 (PACK of 4)1 x FAST-TRACK RANGE 90mm - Semi-Rigid Duct 50M1 x Ancillary Pack for SLC-800 for SLC800/6A-3AC1 x Economy Airvent 100mm Fan with Timer & Shutter1 x Belt Drive Cased Axial Fan - 450mm - L version1 x Elta Quietflow Twin SQT500-1ECL1 x Mellizo XL EcoWatt 3000 - Twin Fan1 x Elta SLC710/4B-3AC - IP551 x DS-2 2-Speed Switch (3 Phase)1 x Isolator Switch - ISOSW1 x Acoustic Box Fans (Inline) - CAB-1501 x Soler & Palau - HCBT/4-900/H - IP551 x KV DUO 400 EC1 x Elta Unpodded Silencer 1D-250mm1 x Bell Mouth Inlet for Elta cased fans - 800mm1 x DS-2/2 2-Speed Switch IP54 (Single Phase)1 x Etaline 355mm - E2-011 x Biflow SB250-CON4-3 - High Temperature Bifurcated Fan1 x Belt Drive Cased Axial Fan - 500mm - H version1 x KV DUO 500 EC (3Ph-400v) with changeover1 x MEV Spider Wireless boost Switch - MEV-SWH-W1 x Economy Airvent 150mm Fan With Pullcord & Shutters1 x MD - Motor Protection Switch (3 Phase)1 x FSAF355B1DX Silencer 395/81 x AXC 355-6/19°-2(B)-P (0.75 kW) - Smoke Extract Fan1 x Elta Quietflow Twin SQT125-1ECL1 x HRU Controller1 x CBA-100 Inlet Flange for CBT-1001 x Ancillary Pack for SLC-355
Reviews
Vectaire Elegance Low Energy DMEV Fan Range
Vectaire Elegance Low Energy DMEV Fan Range
£ 119.00

I've had 2 of these fans for 4 years now, and they are great...