• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,438.15 (excl. VAT)

£ 4,125.78 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x HRB/6-400-APN1 x 204x60mm Elbow Bend with 150mm Fixed Spigot1 x 204x60mm 45 Degree Vertical Bend1 x Soler & Palau - HCBT/4-400/H - IP651 x 204x60mm x 2m Low Profile Plastic Ducting - 2 Meter1 x Hydor HPA400/6-1A1 x Raptor SDA630/4-1EC1 x KD 315 L1 - High Performance Duct Fan1 x Elta Unpodded Silencer 1D-250mm1 x Soler & Palau - Contra Rotating TCBTx2-500 - IP651 x Raptor SDA500/46-3AC1 x Duct Wrap Insulation - AWDW25mm1 x JBS-1250 Flat Roof Upstand for HCTT/4-1000/B1 x Inclined Curb support BI-3 for TH-5001 x Synthetic Air Filter Media - 10mm x 2mtr x 20mtr Roll1 x K 315 L Sileo Metal Tube Fan1 x 220x90mm Elbow Bend with 125mm Fixed Spigot1 x HQS Bathroom Axial Flow Fan - 125mm1 x Silent 100 Window Kit - windowS1 x KV DUO 150 EC1 x Helios AV125 External Wall Fan1 x Elta Quietflow Twin SQT125-1ECL1 x Biflow SB (CYL) Bifurcated Cylindrical Axial Flow Fan - 630mm1 x Axial Roof mounted Extract/Supply Fan- -HCTT/4-1000-B 5.5kw1 x 220x90mm Insulated Rectangular Horizontal 90° Bend1 x KV DUO 400 EC1 x CBP-DC 15/151 x Clearflow CF Roof Mounted Vertical Discharge Centrifugal Fan - CF350/4-1AC - Single Phase1 x HRT/6-630/35-BZ E111 x External weather louvre 2728mmW x 1630mmH1 x S & P Aluminium Axial Fan Louvre Shutter - PER-CR- 5001 x Soler & Palau - HCBB/2-355/H - IP651 x Etamaster EM 250 EC 02 (high Power) inline mix-vent fan1 x CBMT/Q 500-17 3 HEATER KIT1 x Etaline 280mm1 x Acopel F400-710/1801 x Classic SAX23/9AR Window/Wall Mounted1 x Acopel F400-250/1601 x Etaline 355mm - E2-011 x CBMT/Q 150-15 1 HEATER KIT1 x Acopel F400-560/1601 x RS-160L1 x Decor 300-C Bathroom Fan1 x Jetflow-HIT Metal inline - 125mm1 x HXP450/4-1 - 4 Pole - Single Phase1 x Additional shipping charge for offshore islands1 x Direct Delivery Surcharge1 x Wall Mounted Air Curtains - COR-N Series1 x AKOR T3/7 Spare Motor1 x AL 355 EC 01 AXIALINE - High Performance Long Cased Axial Fan1 x Soler & Palau TCBT/6-400/H - IP44
Reviews
DAOSL Back Draft Damper
DAOSL Back Draft Damper
£ 10.53

Look good, works well, except the shaft of the lanellae cuts...