• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,610.06 (excl. VAT)

£ 4,332.07 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
3 x Elta Variable Speed Drive IP66 - 7.5KW1 x FU 15 40 Frequency Inverter2 x Elta Variable Speed Drive IP66 - 2.2KW1 x FU 075 52 Frequency Inverter (IP20)1 x Helios VDS-7 Three Phase Transformer 5-Step1 x FRQ-10A V2 Inverter Speed controller1 x Helios TSD 5.5 Transformer Speed Control (400v)1 x FU 15 16 Frequency Inverter1 x Elta Variable Speed Drive IP66 - 5.5KW1 x Elta Variable Speed Drive IP66 - 1.5KW1 x FRQ5-10A Inverter Speed controller1 x Frequency converter RUCK - FU 075 201 x FU 22 25 Frequency Inverter1 x Frequency converter FU 075 14 - IP661 x Elta Variable Speed Drive IP66 - 4.0KW1 x Elta Variable Speed Drive IP66 - 0.75KW1 x FRQ5-4A V2 Inverter Speed Controller1 x ELTA - Three Phase Transformer 10amps1 x FU 075 04 Frequency Inverter (IP20)1 x ATEX rated 3-phase Speed Control - R-DK4 KT (EX)1 x Helios - FIUK-11KW 24.0A - FREQUENCY INVERTER1 x Elta Variable Speed Drive IP66 - 2.2KW (1ph to 3ph)1 x Elta 10 Amp Electronic single phase speed controller.2 x ELTA - Single Phase Transformer 2amps1 x Electronic extractor fan speed controller - FSC 1.51 x EC6H - Reversible Group Fan Electronic Controller1 x Elta 2 Amp Electronic single phase speed controller.1 x ELTA - Single Phase Transformer 16amps1 x ELTA - Single Phase Transformer 8amps1 x Airvent ceiling fan controller1 x Elta 3 Amp Electronic single phase speed controller with TK1 x EFSC-3N- Single Phase Speed Control1 x Elta 3 Amp Electronic single phase speed controller.1 x ELTA - Single Phase Transformer 12amps1 x Elta 6 Amp Electronic single phase speed controller with TK1 x Elta Variable Speed Drive IP66 - 0.37KW (1ph to 3ph)1 x ELTA - Single Phase Transformer 4amps1 x COM-31 x Elta Variable Speed Drive IP66 - 0.75KW (1ph to 3ph)1 x EFSC-6N- Single Phase Speed Control1 x Elta 6 Amp Electronic single phase speed controller.1 x ELTA - Single Phase Transformer 10amps1 x Elta Variable Speed Drive IP66 - 1.5KW (1ph to 3ph)1 x ACO8AC/EC AutoChangeover panel1 x TTC-2000 Three phase electric heater controller1 x ACOAS/ AC/EC Auto Changeover 8Amp1 x Elta ACO Panel 149-ACO14E2 x EM30-24 Electro-Mechanical Control Panel1 x CONTROL ECOWATT - Basic1 x EC-Vent control board1 x ACO 149-ACO1/EDV1 x Systemair Save Connect 2.0 Internet Module1 x Elta ACO Panel 149-ACO18B1 x S & P Aluminium Axial Fan Louvre Shutter - PER-CR- 6301 x EM30-24 Control Panel Commissioning Service1 x EC-Vent Room Unit1 x U-EK plastic housing IP65 - for use with the U-EK230E Motor Protection1 x Easy-fix termination kit - High Rise Ventilator - EFT1 x REB-CVF 0-10v Controller1 x S & P Aluminium Axial Fan Louvre Shutter - PER-CR- 3551 x Elta Wall Cowl SWC56/631 x Elta Louvre Shutter - 400mm2 x GRA-100 External Grill by S&P1 x Egg Crate Grille with G2 Dust panel filter 1 inch- 300x3001 x Elta Wall Cowl SWC35/401 x Jet Cowl - 315mm1 x S & P Aluminium Axial Fan Louvre Shutter - PER-CR- 7101 x Single Deflection Grille 400mm with OBD damper1 x VTR 500 STD Filter Kit1 x Egg Crate Grille with Dust panel filter 1 inch- 300x3001 x Biflow SB500-CON2-3 - High Temperature Bifurcated Fan1 x CBM Low Pressure Centrifugal Fan - CBM 9/9 4 Pole 550watt 3V (3-Speed)1 x Biflow SB250-CON2-3 - High Temperature Bifurcated Fan2 x CBT-80N Centrifugal1 x DS-2 2-Speed Switch (3 Phase)1 x Vent Axia Trickle & Boost Switch1 x CBM Low Pressure Centrifugal Fan - CBM 9/9 4 Pole 550watt C VR1 x Vent Axia T-Series Wall Model TX9WL1 x ADH E0-450 Flange - 0450 ADHE/RDHE1 x Duct Termination with Mesh - 200mm1 x Biflow SB250-CON4-1 - High Temperature Bifurcated Fan1 x Universal Pipe Fixing Clip1 x Run On Timer - 5s - 4hrs - RT5A1 x Spiral end cap - 80mm1 x Potentiometer EGH 01 - for DDMP Fans1 x CAD-COMPACT 500 ADVANCED N8 - MVHR unit1 x CBM Low Pressure Centrifugal Fan - CBM 9/7 4 Pole 373watt CVR1 x CBM Low Pressure Centrifugal Fan - CBM 10/10 4 Pole 550watt CVR1 x DPD 12PM Delivery Surcharge2 x Vent Axia ACM 100 T (Timer Model) inline mixed flow duct fan1 x Transformer Speed Control - RTRE- 1.5Amp1 x DEF-CBM-RE-7 - Protection Guard1 x 125mm Round Connector with Damper1 x D2E-146-AP47-751 x Elta SLC560/4C-3AC - IP551 x Slimline 150 High Efficiency, Low Profile Heat Recovery Unit1 x Vent Axia W300310 Controller Electronic 1.5A1 x PM230-TF, AC 230V Damper Actuator, Spring Return, 2 x SPDT, 72C Thermal Fuse2 x Helios HQW-200/2 - IP551 x SPI-100 C Iris damper1 x Electrostatic Precipitator - 1H x 3W1 x Helios ESA-1 Surface mounted Speed Control 1amp2 x DEF-140T Inlet Guard for the CBT-100N1 x MTP 10, 10K, Speed control1 x CBP-18/18-RC Belt Driven Centrifugal Fans1 x Transformer Speed Control - RTRE- 5.0Amp1 x MTS10- extractor fan 3 step switch2 x WSD 100 (1060x1060x70)2 x CBT-100N Centrifugal1 x Lo-Carbon Silhouette 100T (Timer)2 x SD-MUB Vibration pad set1 x CBB-60N Centrifugal1 x RUCK MTP 20, 10K, Speed control1 x MWS 5 – Transformer Controller With Motor Protection Unit
BD7/7 centrifugal M4 0.13Kw
BD7/7 centrifugal M4 0.13Kw
£ 345.00 now £ 300.00
Reviews
Transformer (silent) speed controller - RE 1.5 Amp
Transformer (silent) speed controller - RE 1.5 Amp
£ 132.29

Unbelievable! With TDmixvent500: noise reduction minimum 50%...