• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,610.06 (excl. VAT)

£ 4,332.07 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x D2E146-AP47-331 x G2E160−AL19−56 FLUE FAN1 x EBM-Papst D2E097-BK76-98 Double inlet1 x DIC 180 T LG (1IC1881) Forward Curved Blade Centrifugal Fan1 x W2S130-AA03-011 x KRJ - 120 Inlet Guard for CBB/CBT fans1 x Jetflow-HIT Metal inline - 100mm1 x DEF-1000-AN1 x ERM 18 protection guard - SGM 18 EX1 x JETLINE-100 - In Line Centrifugal Duct Fan1 x EX 140A-4C Mounting Kit for 160mm Duct1 x Ducting 45 Degree Bend - 1120mm1 x AR Sileo 500 Cased Axial Fan Guard - SG AXC/AM/AR 5001 x MV EC 100 Multivent1 x Ducting 15 Degree Bend - 1120mm1 x Impeller Side Guard - 560mm1 x Impeller Side Guard - 900mm1 x Impeller Side Guard - 800mm1 x Impeller Side Guard - 315mm1 x Impeller Side Guard - 400mm1 x DEF-900AN1 x FSD-TD 400 x 400 Fire and Smoke Damper, S, EASY FIX AF, GALV Case, GALV Blades, PM230-TF (SC)1 x TD250 (110v) Mixvent - 100mm - TD2501 x TDID 4 - WOODS Auto Transformer (3 Phase)1 x Impeller Side Guard - 1000mm1 x Metal Inline Fan - VENT-100NK1 x Impeller Side Guard - 710mm1 x DEF-CBM-RE-7 - Protection Guard1 x Impeller Side Guard - 500mm1 x Impeller Side Guard - 630mm1 x RAE-2G - 2amp Single Phase Transformer Controller1 x Impeller Side Guard - 250mm1 x Ducting 30 Degree Bend - 1120mm1 x Female Ducting Connector - 1120mm1 x CBMT/Q 315-54 1 HEATER KIT1 x DEF-800AN1 x DEF-140T Inlet Guard for the CBT-100N1 x FSD-TD 400 x 350 Fire and Smoke Damper, S, EASY FIX AF, GALV Case, GALV Blades, PM230-TF (SC)1 x FSD-TD Fire and Smoke Damper, 800mm x 200mm, EASY FIX AF, GALV Case, GALV Blades, PM230-TF1 x EX 140A-4C Mounting Kit for 125mm Duct1 x TDID 11 - WOODS Auto Transformer (3 Phase)1 x Impeller Side Guard - 450mm1 x Ducting 90 Degree Bend - 1120mm1 x TDID 2.5 - WOODS Auto Transformer (3 Phase)1 x Hydor HPA400/6-1A1 x HCFB/4-400mm plastic impeller plate fan1 x B-flow Impeller HCBB/T-355mm1 x Helios HQW-400/4 - IP551 x HCFT/4-400/H-BPN E20,P 0.25KW1 x FSD-TD 450 x 200 Fire and Smoke Damper, S, EASY FIX AF, GALV Case, GALV Blades, PM230-TF (SC)1 x Duct Split Rings (Pair) -1120mm1 x 400mm x 400mm Metal Grille Box - 250mm Side Entry1 x Spiral Ducting 3 Meters - 1120mm1 x FSD-TD 300 x 300 Fire and Smoke Damper, S, EASY FIX AF, GALV Case, GALV Blades, PM230-TF (SC)1 x FM-200 Flexible Connector Sleeve - 200mm1 x Impeller Side Guard - 350mm1 x EBM-papst Motorised Impeller - A6D800-AD01-011 x B-flow Impeller HCBB/T-450mm1 x FSD-TD 500 x 300 Fire and Smoke Damper, S, EASY FIX AF, GALV Case, GALV Blades, PM230-TF (SC)1 x GB-KW 355 Drain pan for Giga Box Fans - 355mm1 x AR Sileo 400 Cased Axial Fan Guard - SG AXC/AM/AR 4001 x Male Ducting Connector - 1120mm1 x ADH E0-250 Flange - 0250 ADHE/RDHE1 x HRB/6-400-APN1 x B-flow Impeller HCBB/T-560mm1 x CBMT/Q 150-27 1 HEATER KIT1 x FSD-TD 450mm Fire and Smoke Damper, Type C, EASY FIX AF, GALV Case, GALV Blades, PM230-TF (SC)1 x Mounting Feet 200-250 (pair) for ADH E0-02501 x 200mm EC BOX FAN - WOODS EC SINGLE FAN 2001 x Helios HQW-400/6 - IP551 x TDID 8 - WOODS Auto Transformer (3 Phase)1 x FSD-TD 550 x 250 Fire and Smoke Damper, S, GALV Case, GALV Blades, PM230-TF (SC)1 x London Fans Impeller - IMP710/160/10A/20°/28mm kw1 x Insulated extract Plenum 8+11 x LF-ME04F071LC3AC1 x Spigot plate - 160mm1 x 150mm EC BOX FAN - WOODS EC SINGLE FAN 1501 x CBMF 250-6,0 400V/2 Duct heater1 x Elta SPA400/4-1AC - IP541 x HRB/4-400-APN1 x FSD-TD Fire and Smoke Damper, 1000mm x 600mm, EASY FIX AF, GALV Case, GALV Blades, PM230-TF1 x Remote controller FLEX - for VEKO INT1 x Elta SCP400/4-3AC - IP551 x Elta Podded Silencer 1D - 630mm - Compact1 x CBMT/Q 315-120 3 HEATER KIT1 x Soler & Palau - HCBB/6-400/H - IP651 x Ducting T Piece Equal - 160mm1 x MUB/T-S 100 630D4 Centrifugal box fan, 120°C Continuous, Insulated1 x CBMT/Q 200-30 1 HEATER KIT1 x Hydor HPA400/4-1A1 x HRB/4-400-BPN1 x Soler & Palau - HCBT/4-400/H - IP651 x Elta SPA400/46-3AC - IP541 x EuroSeries (ESP) - Plate Mounted Axial Fans 400-141 x VEKA INT 2000/15.0-L1 EKO1 x MBE Electric Heater Battery - 500/18 T1 x HRT/4-400-BPN1 x CBMT/Q 125-12 1 HEATER KIT1 x CBMT/Q 315-30 1 HEATER KIT1 x Spiral end cap - 160mm1 x CBMT/Q 315-90 3 HEATER KIT1 x HCFT/4-400mm plastic impeller plate fan
LINEO 200 QUIET
LINEO 200 QUIET
£ 293.00 now £ 235.00
Reviews
TD-SILENT 350/125
TD-SILENT 350/125
£ 178.68

Excellent low noise fan, I've got one unit running years and...