• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,438.15 (excl. VAT)

£ 4,125.78 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x Spiral end cap - 355mm1 x SEL355/2-1AC1 x CBTR/2-451-4kw1 x 110 x 54mm Vertical 45 Degree Bend1 x Ducting Reducers Short - 355mm-315mm1 x SEL355/4-1AC1 x SWF-150X Sidewall Mounted Extractor Fan1 x Duct Suspension Rings - 355mm1 x CBT-100N Centrifugal1 x Duct Fast Clamps - 150mm1 x Ducting Y Piece - 150mm1 x 110 x 54mm Low Profile Plastic Ducting - 1 Meter1 x CBPx2-9/7-D1 x Helios GigaBox 355mm GBD 355/4/4 centrifugal1 x Male Ducting Connector - 150mm1 x 110 x 54mm Horizontal 90 Degree Bend1 x 110 x 54mm Low Profile Plastic Ducting - 2 Meter1 x Helios AV200 External Wall Fan1 x Spigot plate - 630mm1 x GB-WSD 355 Weather Protection hood for the Giga-Box Fans - 355mm1 x Elta Variable Speed Drive IP66 - 0.37KW (1ph to 3ph)1 x Curved boot - 630mm1 x EnergiSava 210 Low Energy Heat Recovery Unit1 x CTI CVA-N 250/315 Outdoor cover for CVAB/T Fans1 x GB-WSD 560 Weather Protection hood for the Giga-Box Fans - 560mm1 x MELL-USD 6000 Rectangular to Circular Adaptor 450 Dia1 x Ducting 45 Degree Bend - 630mm1 x CBM 10/10 - 373watt - 6 Pole1 x Elta Standard Ambient Flexible Connector - 250mm1 x Elta Quietflow Twin SQT250-1ECL1 x Ductwrap Insulation DW501 x HVWC800 WALL COWL - for use with the HV-800 belt driven fans1 x Elta Variable Speed Drive IP66 - 0.75KW1 x Duct Split Rings (Pair) -630mm1 x Elta 6 Amp Electronic single phase speed controller.1 x FU 15 40 Frequency Inverter1 x Ducting 90 Degree Bend - 630mm1 x FRQ5-10A Inverter Speed controller1 x Frequency converter FU 075 14 - IP661 x ASSG/F 500-560 Flex. conn. DVG1 x Frequency converter RUCK - FU 075 201 x Helios TSD 5.5 Transformer Speed Control (400v)
Reviews
Transformer (silent) speed controller - RE 1.5 Amp
Transformer (silent) speed controller - RE 1.5 Amp
£ 125.99

Incredible, Perfect, Silent and Fast delivery ! Thanks "Just...