• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,438.15 (excl. VAT)

£ 4,125.78 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x EM30-24 Control Panel Commissioning Service1 x EMF 500-14 - ECO MIXED FLOW IN-LINE FANS1 x CONTROL ECOWATT - Basic1 x EC6H - Reversible Group Fan Electronic Controller1 x Soler & Palau - HCBT/6-1000/H - IP551 x Impeller for London Fans unit - 535/1601 x HV Wall Mounted Belt Drive Fan 1000mm 220V to 240V / 50Hz 0.75kW - Single Phase1 x Soler & Palau - HXTR/4-355/H - IP541 x 5-Speed Controller for use with Elta SAX Classic Fans1 x HRT/4-355-BPN1 x Soler & Palau - HCBT/6-900/H - IP551 x Soler & Palau - HCBB/2-355/H - IP651 x CBB-100N Centrifugal1 x KD 250 M1 Circular duct fan1 x Etaline 280mm1 x CBPx2-9/7-D1 x Jetflow-HIT Metal inline - 250mm1 x ZAP 710-61 Plate axial fan1 x Ducting T Piece Equal - 300mm1 x Soler & Palau TCBB/6-355/H - IP441 x ACO3/B Changeover Panel (Three Phase)1 x Commercial Single or 3 phase Fan Reversing Switch - RS11 x EBB-250 M DESIGN Centrifugal Extractor Fan1 x DOL Starter with Isolator - Three phase1 x Elta Prema LCD Display1 x FAST-TRACK RANGE 75mm - Seal Ring (1 bag of 10)1 x Elta SLC630/4A-3AC - IP551 x AMD-630/2 - High Performance Cased Axial Fan1 x Duct Tape - Silver - DTape1 x Flexible PVC Ducting - 15 Mtr1 x EQ641406 630mm Max Fan1 x Belt Drive Cased Axial Fan - 630mm - L version1 x Elta Turboflow-TF - 630mm - Three phase1 x CVAT Acoustic Kitchen Fan & Inverter Kit - CVAT/4-12000/560 ND - Pack 81 x RSK400 - Back Draught Shutter1 x Belt Drive Cased Axial Fan - 800mm - H version1 x SPI-150 C Iris damper1 x Biflow SB315-CON2-3 - High Temperature Bifurcated Fan1 x Belt Drive Cased Axial Fan - 560mm - H version1 x KABT High Temp Acoustic Kitchen Fan & Inverter Kit - KABT/4-4000/355 ND - Pack 21 x Belt Drive Cased Axial Fan - 560mm - L version1 x Belt Drive Cased Axial Fan - 500mm - L version1 x JETLINE-125 - In Line Centrifugal Duct Fan1 x Multileaf Volume Control Dampers -600/600 Rectangular Flanged1 x KABT High Temp Acoustic Kitchen Fan & Inverter Kit - KABT/4-12000/560 ND - Pack 51 x Biflow SB250-CON4-1 - High Temperature Bifurcated Fan1 x Belt Drive Cased Axial Fan - 800mm - G version1 x EBM-papst Motorised Impeller - A6D800-AD01-011 x HRB/6-400-APN1 x CC-800-5.5kw1 x F7/G4 filter kit for IDEO HR unit1 x HCFT/4-315mm plastic impeller plate fan1 x Helios HQW-400/6 - IP55
Reviews
Transformer (silent) speed controller - RE 1.5 Amp
Transformer (silent) speed controller - RE 1.5 Amp
£ 125.99

Unbelievable! With TDmixvent500: noise reduction minimum 50%...