• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,610.06 (excl. VAT)

£ 4,332.07 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x KBA- Inlet Mounting 2251 x EBM-Papst D2E097-BK76-98 Double inlet1 x ENV 100 12v transformer SELV1 x KBD- outlet mounting flange for CRMT 2501 x Elta Cased Axial Flange - 250mm1 x Rosenberg ATEX DKHM 355-4SW.110.5DF-E751 x Spigot plate - 160mm1 x Flanged Spigot - 450mm1 x Male Ducting Connector - 800mm1 x Spigot plate - 800mm1 x Elta 10 Amp Electronic single phase speed controller.1 x ELTA - Single Phase Transformer 2amps1 x Electronic extractor fan speed controller - FSC 1.51 x EC6H - Reversible Group Fan Electronic Controller1 x 5-Speed Controller for use with Elta SAX Classic Fans1 x Elta 2 Amp Electronic single phase speed controller.1 x Elta 6 Amp Electronic single phase speed controller with TK1 x ELTA - Single Phase Transformer 8amps1 x EFSC-3N- Single Phase Speed Control1 x ELTA - Single Phase Transformer 16amps1 x Elta 3 Amp Electronic single phase speed controller with TK1 x ELTA - Single Phase Transformer 12amps1 x Airvent ceiling fan controller1 x Elta 3 Amp Electronic single phase speed controller.1 x ELTA - Single Phase Transformer 4amps1 x COM-31 x AIRVENT speed control - AIR4019611 x KMBI 225 Connector rectangular/circular to install on the discharge of CMT1 x EFSC-6N- Single Phase Speed Control1 x Elta 6 Amp Electronic single phase speed controller.1 x ELTA - Single Phase Transformer 10amps1 x S & P Aluminium Axial Fan Louvre Shutter - PER-CR- 6301 x S & P Aluminium Axial Fan Louvre Shutter - PER-CR- 5001 x Easy-fix termination kit - High Rise Ventilator - EFT1 x S & P Aluminium Axial Fan Louvre Shutter - PER-CR- 355
Reviews
EM 250-E2M 01- Etamaster-250
EM 250-E2M 01- Etamaster-250
£ 128.80

Really well made but comes with no speed controler? ?and can...