• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,610.06 (excl. VAT)

£ 4,332.07 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x Female Ducting Connector - 160mm1 x FlameProof Plate Axial Fan - Single Phase - 7.5 inches - Eexd IIC T4 -2pole1 x Compact SCD630/4-3AC1 x Soler & Palau HXM-300mm1 x HIMF - Mixed Flow Fan 125mm Inline Fan1 x Soler & Palau TCBB/6-630/L - IP651 x Eco-Loft Positive Input Ventilation System - PIV Loft Mounted -EVL-HAS1 x Raptor SDA630/4-3EC1 x Helios HRFW 355/4 TK1 x Soler & Palau - Contra Rotating TCBTx2-630 - IP651 x Soler & Palau TCBB/4-355/H - IP441 x HQD 630/4 EX - ATEX Rated Plate Axial Fan (4-pole)1 x *NEW* TD EVO-100 PF ECOWATT - Environmentally Friendly Energy Efficient Inline Fan1 x EM 315-E2M 01- Etamaster-3151 x Contra Rotating TCBBx2-630 Cased Axial - Single Phase - IP65 - Soler & Palau2 x Spiral Ducting 1 meter - 160mm1 x Soler & Palau TCBT/6-630/H - IP651 x FlameProof Plate Axial Fan - Three Phase - 10.5 inches - Eexd IIC T4 -2pole1 x Elta SLC355/4-3AC - IP551 x Spiral Ducting 3 Meters - 300mm1 x Flat Roof Terminal -OFT 5 - Bitumen1 x *VORT HRW 30 MONO Evo - Single Room Heat Recovery Unit,1 x Elta Wall Cowl SWC45/501 x Helios DDF-250 Roof Cowl1 x Anti Vibration Duct Suspension Rings - 300mm1 x Duct Suspension Rings - 300mm1 x GEO Ground Source Heat Exchanger1 x ASSG/F 500-560 Flex. conn. DVG1 x Spigot plate - 300mm1 x CAB-200 ECOWATT Energy Efficient Acoustic Box Fan1 x Helios DDF-315 Roof Cowl1 x Carriage1 x Miniflow SMF Horizontal Roof Cowl SMF131 x Elta Wall Cowl SWC25/311 x Elta Wall Cowl SWC56/631 x EnergiSava 210 Low Energy Heat Recovery Unit1 x Acopel F400-355/1601 x Acopel F400-180/1601 x Acopel F400-710/1801 x Flat Roof Terminal -OFT 1 - Felt & Asphalt 110mm1 x Acopel F400-315/1601 x Elta Standard Ambient Flexible Connector - 250mm1 x Singleflow SSDL200-1EC1 x AKOR T3/7 Spare Motor
Reviews
Circular Inline Silencers - 0.6M long - SLU-600
Circular Inline Silencers - 0.6M long - SLU-600
£ 50.56

I have a loft mount extractor fan which was very noisy. I ...