• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,610.06 (excl. VAT)

£ 4,332.07 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x Ducting 90 Degree Bend - 400mm1 x Belt Drive Cased Axial Fan - 560mm - H version1 x Elta Turboflow-TF - 560mm - Three phase1 x Soler & Palau TCBB/4-560/H - IP651 x Elta Turboflow-TF - 560mm - Single phase1 x Soler & Palau - Contra Rotating TCBTx2-560 - IP651 x Elta SLC560/2-3AC - IP551 x Raptor SDA560/6-1AC1 x Elta SLC560/4C-3AC - IP551 x Elta SLC560-1EC -IE5 Motor- IP551 x Raptor SDA560/4-1AC1 x Elta SLC560/4A-3AC - IP551 x HXP560/4-3 - 4 Pole - Three Phase1 x Elta SLC560/4A-1AC - IP551 x Elta SLC560/4B-1AC - IP551 x Elta SLC560/4B-3AC - IP551 x HRFD 400/4 EX Atex Rated 400mm Cased Axial Fan 400v1 x Elta SLC560/2-3AC with inverter Drive & APK Mounting Kit1 x Elta Turboflow Max TF - 560mm - Three phase1 x Belt Drive Cased Axial Fan - 560mm - L version1 x CC 564 T 1.5KW VS-8-45 (1CC5679) Ducted Axial Fan1 x Raptor SDA560/46-3AC1 x 56 MAXFAN Compac - EJ563236 - 560mm Fan and Inverter Kit 1PH to 3PH1 x Compact SCD560/4-1AC1 x Elta Turboflow Max TF050J23-A6-10/INV1-31 x SAVE VTC 700 R Heat Recovery Unit1 x Flanged Spigot - 355mm1 x Villavent BF VR700 E and DC STD Filter Kit1 x TTC-2000 Three phase electric heater controller1 x ACO8AC/EC AutoChangeover panel1 x ACOAS/ AC/EC Auto Changeover 8Amp1 x EC-Vent control board1 x CONTROL ECOWATT - Basic1 x ACO 149-ACO1/EDV1 x EM30-24 Electro-Mechanical Control Panel1 x U-EK plastic housing IP65 - for use with the U-EK230E Motor Protection1 x EC-Vent Room Unit1 x Systemair Save Connect 2.0 Internet Module1 x Elta ACO Panel 149-ACO18B1 x EM30-24 Control Panel Commissioning Service2 x Vent Axia ACM 100 T (Timer Model) inline mixed flow duct fan1 x Vent Axia ACM 125 T (Timer Model) inline mixed flow duct fan1 x Remote controller FLEX - for VEKO INT1 x Helios TSW 7.5 Amp Transformer speed controller1 x Helios TSW MCB Amp Transformer speed controller1 x HCFC 1.7 - Reversible Speed Controller for HCF sweep fans1 x Helios TSW 0.3Amp Compact Transformer speed controller1 x Helios TSW 1.5 Amp Transformer speed controller
BD9/9 centrifugal M4 0.35Kw
BD9/9 centrifugal M4 0.35Kw
£ 399.00 now £ 350.00
Reviews
EM 250-E2M 01- Etamaster-250
EM 250-E2M 01- Etamaster-250
£ 128.80

Really well made but comes with no speed controler? ?and can...