• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,438.15 (excl. VAT)

£ 4,125.78 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x 125mm Insulated 90 Degree Bend1 x Acoustic MiniBox Fan - MINI-BOX 1001 x Ducting T Piece Equal - 450mm1 x 220 x 90mm Duct to Duct Connector for use with Insulated Thermal Ducting1 x Metal Inline Fan - VENT-125NK1 x GB-WSD 560 Weather Protection hood for the Giga-Box Fans - 560mm1 x Duct Termination with Mesh - 450mm1 x GB-WSD 500 Weather Protection hood for the Giga-Box Fans - 500mm1 x Soler & Palau TCBT/6-800/H - IP651 x Soler & Palau - HCBB/2-315/H - IP651 x Soler & Palau - HCBT/2-315/H - IP651 x 204x60mm x 1m Insulated Rectangular Duct1 x SLIMPAK 100 EC BOX FAN - 100mm Energy Efficient Acoustic Box Fan1 x GB-WSD 450 Weather Protection hood for the Giga-Box Fans - 450mm1 x Elta SCP315/4-3AC - IP551 x Ducting 45 Degree Bend - 450mm1 x ILTM-500/560/630 - Motor Cover for ILHT Fans - 51337593001 x S & P Aluminium Axial Fan Louvre Shutter - PER-CR- 3551 x Envirovent Silent MV160/100S Mixvent - 100mm - (5 year warranty)1 x 1mtr Insulated Round Ducting - 125mm1 x Soler & Palau TCBT/6-800/G - IP651 x JETLINE-125 - In Line Centrifugal Duct Fan1 x HRT/4-315-BPN1 x CTI CVA-N 500/560 Outdoor cover for CVAB/T Fans1 x Acoustic Box Fans (Inline) - CAB-355 RE1 x KVK SLIM 355 EC - Centrifugal Circular Duct Fan1 x HCFT/6-1000-HX plastic impeller plate fan1 x Soler & Palau - HCBT/6-1000/H - IP551 x Elta Wall Cowl SWC35/401 x *VORT HRW 30 MONO Evo HCS - Single Room Heat Recovery Unit,1 x Elta Raptor SFB ATEX Plate Mounted Axial Fan- 350mm1 x CADB/T-HE PRO-REG Series1 x filter pack (set of 2) pt no. 4438891 x 204x60mm Rectangular to 100mm Round Adaptor1 x Curved Blade Grille 600x600 (2way blow)1 x Round ceiling diffuser 400mm1 x *VORT HRW 30 MONO Evo - Single Room Heat Recovery Unit,1 x Elta Wall Cowl SWC25/311 x Ducting 45 Degree Bend - 500mm1 x Duct Split Rings (Pair) -500mm1 x Miniflow SMF Horizontal Roof Cowl SMF131 x Flat Roof Terminal -OFT 5 - Asphalt1 x Kitchen Grease Filter - Mesh Type Non standard 450mm x 150mm x 22mm ( CEF450 Replacement)1 x Metal Inline Fan - VENT-100NK1 x HXP450/6-3 - 6 Pole - Three Phase1 x MUB 016 200EC - Acoustic EC Box Fan1 x HXP450/4-1 - 4 Pole - Single Phase1 x Kitchen Grease Filter - Mesh Type NON standard 390mm x 240mm x 40mm Actual1 x Round ceiling diffuser 300mm1 x 204x60mm x 1000mm Long Hi-Flow Duct Silencer1 x Circular Ceiling Diffuser - TST 2001 x KVK Slim 355 - Low profile Semi Acoustic Box Fan1 x HV Wall Mounted Belt Drive Fan 800mm 220V to 240V / 50Hz 0.75kW - Single Phase
Reviews
Vectaire Elegance Low Energy DMEV Fan Range
Vectaire Elegance Low Energy DMEV Fan Range
£ 119.00

I've had 2 of these fans for 4 years now, and they are great...